A. 70% copper and 30% zinc
B. 90% copper and 10% tin
C. 85-92% copper and rest tin with little lead and nickel
D. 70-75% copper and rest tin
E. 90% copper and 10% zinc
Related Mcqs:
- Bell metal contains_____________________?
A. 70% copper and 30% zinc
B. 90% copper and 10% tin
C. 85-92% copper and rest tin with little lead and nickel
D. 70-75% copper and rest tin
E. 70-75% copper and rest zinc and tin - Aluminium bronze contains__________________?
A. 94% aluminium, 4% copper and 0.5% Mn, Mg, Si and Fe
B. 92.5% aluminium, 4% copper, 2% nickel, and 1.5% Mg
C. 10% aluminium and 90% copper
D. 90% magnesium and 9% aluminium with some copper
E. 10% aluminium and 90% tin - Phosphor bronze contains____________________?
A. 0.5% of phosphorous
B. 1% phosphorous
C. 2.5% phosphorous
D. 5% phosphorous
E. none of the above - Aluminium bronze contains aluminium and copper in the ratio of___________________?
A. 50 : 50
B. 40 : 60
C. 60 : 40
D. 10 : 90
E. 90 : 10 - The crystal of alpha iron is ____________________?
A. body centred cubic
B. face centred cubic
C. hexagonal close packed
D. cubic structure
E. orthorhombic crystal - Process of austempering results in__________________?
A. formation of bainite structure
B. carburised structure
C. martenistic structure
D. lamellar layers of carbide distributed throughout the structure
E. relieving of stresses throughout a component - An example of amorphous material is____________?
A. zinc
B. lead
C. silver
D. glass
E. brass - Railway rails are normally made of_______________?
A. mild steel
B. alloy steel
C. high carbon
D. tungsten steel
E. cast iron steel - The ultimate tensile strength of low carbon steel by working at a high strain rate will_________________?
A. decrease
B. increase
C. remain constant
D. first increase and then decrease
E. first decrease and then increase - Which of the following is not the correct method of increasing fatigue limit __________________?
A. shot peening
B. nitriding of surface
C. cold working
D. surface decarburisation
E. under-stressing