A. shot peening
B. nitriding of surface
C. cold working
D. surface decarburisation
E. under-stressing
Related Mcqs:
- Pick up the correct step used for scheduling a project by C.P.M.__________________?
A. a project is divided into various activities
B. required time for each activity is established
C. sequence of various activities is made according to their importance
D. network is drawn by connecting the activities and the events
E. all of the above - Gardually increasing temperature of flue gases at inlet to chimney for given steam outputs is an indication of__________________?
A. higher effectiveness of boiler
B. high calorific value coal being burnt
C. fouling of heat transfer surfaces
D. raising of steam temperature
E. leakage of air - Which of the following statements is correct ?
A. All the irreversible engines have same efficiency
B. All the reversible engines have same efficiency
C. Both Rankine and Caront cycles have same efficiency between same temperature limits
D. All reversible engines working between same temperature limits have same-efficiency
E. Between same temperature limits, both petrol and diesel engines have same efficiency - Pick up the correct statement from the following?
A. critical path method is an improvement upon bar chart method
B. critical path method provides a realistic approach to the daily problems
C. critical path method avoids delays which are very common in bar chart
D. critical path method was invented by Morgan R. Walker of Dupot and James E. Kelley of Remington U.S.A in 1957
E. all of the above - Pick up the correct statement from the following?
A. the float may be positive, zero or negative
B. if the float is positive and the activity is delayed by a period equal to its total float, the completion of project in not delayed
C. if the float of an activity is negative, delay in its performance is bound to delay the completion of project
D. if the float of an activity is zero, the activity is critical and any delay in its performance will delay the whole project
E. all of the above - Pick up the correct statement from the following?
A. programmer evaluation and review technique is event oriented
B. programmer evaluation and review technique is not event oriented
C. critical path method is event oriented
D. critical.path method is not activity oriented
E. none of the above - Heating value of fuel used is as on fired basis. If it is reported for dry or moisture free fuel, then latter should be multiplied by the following factor to correct for as fired value ___________________?
A. (1- moisture content)
B. (1 + moisture content)
C. 1 + moisture content
D. 1 – moisture content - The correct composition of Babbit metal is__________________?
A. 87.75% Sn, 4% Cu, 8% Sb, 0.25% Bi
B. 90% Sn, 2% Cu, 4% Sb, 2% Bi, 2% Mg
C. 87% Sn, 4% Cu, 8% Sb, 1% Al
D. 82% Sn, 4% Cu, 8% Sb, 3% Al, 3% Mg
E. none of the above - The correct sequence for descending order of machinability is _____________________?
A. grey cast iron, low carbon steel, wrought iron
B. low carbon steel, grey cast iron, wrought iron
C. wrought iron,low carbon steel, grey cast iron
D. wrought iron, grey cast iron, low carbon steel
E. grey cast iron, wrought iron, low carbon steel - Constantant an alloy used in thermocouples is an alloy of __________________?
A. copper and tin
B. copper and zinc
C. copper and iron
D. copper and nickel
E. copper and chromium