A. grey cast iron, low carbon steel, wrought iron
B. low carbon steel, grey cast iron, wrought iron
C. wrought iron,low carbon steel, grey cast iron
D. wrought iron, grey cast iron, low carbon steel
E. grey cast iron, wrought iron, low carbon steel
Related Mcqs:
- The machinability of steel is increased by___________________?
A. silicon and sulphur
B. phosphorous, lead and sulphur
C. sulphur, graphite and aluminium
D. phosphorous and aluminium
E. none of the above - The hardness of steel primarily depends on _____________________?
A. %age of carbon
B. %age of alloying elements
C. heat treatment employed
D. method of manufacture
E. shape of carbides and their distribution in iron - Alnico, an alloy used extensively for permanent magnets contains iron, nickel, aluminium and cobalt in the following ratio _____________________?
A. 50 : 20 : 20 : 10
B. 40 : 30 : 20 : 10
C. 50 : 20 : 10 : 20
D. 30 : 20 : 30 : 20
E. 50 : 10 : 20 : 20 - Corrundum contains more than 95% _____________________?
A. steel
B. A1203
C. Si02
D. MgO
E. german silver - For pipes, turbulent flow occurs when Reynolds number is _____________________?
A. less than 2000
B. between 2000 and 4000
C. more than 4000
D. less than 4000
E. none of the above - Surface energy per unit area of a surface is numerically equal to _____________________?
A. atmospheric pressure
B. surface tension
C. force of adhesion
D. force of cohesion
E. viscosity - In regenerative air preheater, the heat is transferred _____________________?
A. from a metal wall from one medium to another
B. from heating an intermediateanaterial and then heating the air from this material
C. by direct mixing
D. heat is transferred by bleeding some gas from furnace
E. none of the above - Steam exhaust from high pressure turbine is reheated in _____________________?
A. boiler drum
B. superheater tubes
C. economiser
D. a separate coil
E. a separate coil located in convection path - The ultimate analysis of fuel lists _____________________?
A. various chemical constituents, carbon, hydrogen, oxygen etc, plus ash as per-cents by volume
B. various chemical constituents, carbon, hydrogen, oxygen, etc, plus ash as per-cents by weight
C. fuel constituents as percents by volume of moisture, volatile, fixed carbon and ash
D. fuel constituents as percents by weight of moisture, volatile, fixed carbon and ash
E. moisture and ash free heating value - Overfire burning is the phenomenon of _____________________?
A. supply of excess, air
B. supply of excess coal
C. burning CO and unburnts in upper zone of furnace by supplying more air
D. fuel bed firing
E. none of the above