A. supply of excess, air
B. supply of excess coal
C. burning CO and unburnts in upper zone of furnace by supplying more air
D. fuel bed firing
E. none of the above
Related Mcqs:
- For burning 1 kg of carbon to CO as per chemically correct combusiton, amount of air required is___________________?
A. 1 kg
B. 4/3kg
C. 8/3kg
D. 2 kg
E. 16/3 kg - Spontaneous combustion is a phenomenon in which____________________?
A. all the fuel burns instantaneously producing high energy release
B. fuel burns with less air
C. coal bursts into flame without any external ignition source but by itself due to gradual increase in temperature as a result of heat released by combination of oxygen with coal
D. explosion in furnace
E. none of the above - Stress relaxation is- the phenomenon ___________________?
A. in which parts are not loaded
B. in which stress remains constant on in-creasing load
C. in which deformation tends to loosen the joint and produces a stress reduced
D. stress reduces on increasing load
E. none of the above - Weld decay is the phenomenon found with _________________?
A. cast iron
B. mild steel
C. non-ferrous materials
D. wrought iron
E. stainless steel - In regenerative air preheater, the heat is transferred _____________________?
A. from a metal wall from one medium to another
B. from heating an intermediateanaterial and then heating the air from this material
C. by direct mixing
D. heat is transferred by bleeding some gas from furnace
E. none of the above - Steam exhaust from high pressure turbine is reheated in _____________________?
A. boiler drum
B. superheater tubes
C. economiser
D. a separate coil
E. a separate coil located in convection path - The ultimate analysis of fuel lists _____________________?
A. various chemical constituents, carbon, hydrogen, oxygen etc, plus ash as per-cents by volume
B. various chemical constituents, carbon, hydrogen, oxygen, etc, plus ash as per-cents by weight
C. fuel constituents as percents by volume of moisture, volatile, fixed carbon and ash
D. fuel constituents as percents by weight of moisture, volatile, fixed carbon and ash
E. moisture and ash free heating value - The hardness of steel primarily depends on _____________________?
A. %age of carbon
B. %age of alloying elements
C. heat treatment employed
D. method of manufacture
E. shape of carbides and their distribution in iron - Corrundum contains more than 95% _____________________?
A. steel
B. A1203
C. Si02
D. MgO
E. german silver - The correct sequence for descending order of machinability is _____________________?
A. grey cast iron, low carbon steel, wrought iron
B. low carbon steel, grey cast iron, wrought iron
C. wrought iron,low carbon steel, grey cast iron
D. wrought iron, grey cast iron, low carbon steel
E. grey cast iron, wrought iron, low carbon steel