(a) A. operating schedule of generating units
B. sizes of generating units
C. total installed capacity of the plant
D. all of the above
Related Mcqs:
- Load center in a power station is___________?
A. center of coal fields
B. center of maximum load of equipments
C. center of gravity of electrical system - Load carrying capacity of belt conveyor is about___________?
A. 20 to 40 tonnes/hr
B. 50 to 100 tonnes/hr
C. 100 to 150 tonnes/hr
D. 150 to 200 tonnes/hr - Which of the following load is responsible for lower power factor of supply system__________?
A. induction motors
B. resistive loads
C. synchronous Motors
D. all of the above - Load factor of a power station is defined as____________?
A. maximum demand/average load
B. average load x maximum demand
C. average load/maximum demand
D. none of the above - If the load factor of a power station is high then its cost of generation will be_______?
A. High.
B. Low.
C. Remain same.
D. Depend upon plant type. - The ideal load factor should be_____________?
A. unity
B. zero
C. negative.
D. infinity. - The commercial sources of energy are____________?
A. solar, wind and biomass
B. fossil fuels, hydropower and nuclear energy
C. wood, animal wastes and agriculture wastes
D. none of the above - For the same draught produced the power of induced draught fan as compared to forced draught fan is___________?
A. less
B. more
C. same
D. not predictable - In a regenerative surface condenser_____________?
A. there is one pump to remove air and condensate
B. there are two pumps to remove air and condensate
C. there are three pumps to remove air, vapour and condensate
D. there is no pump, the condensate gets removed by gravity - Demand factor is defined as___________?
A. average load/maximum load.
B. maximum demand/connected load
C. connected load/maximum demand.
D. average load x maximum load