A. there is one pump to remove air and condensate
B. there are two pumps to remove air and condensate
C. there are three pumps to remove air, vapour and condensate
D. there is no pump, the condensate gets removed by gravity
Related Mcqs:
- Regenerative cycle thermal efficiency_______________?
A. is always greater than simple Rankine thermal efficiency
B. is greater than simple Rankine cycle thermal efficiency only when steam is bled at particular pressure
C. is same as simple Rankine cycle thermal efficiency
D. is always less than simple Rankine cycle thermal efficiency - In a regenerative feed heating cycle, the optimum value of the fraction of steam extracted for feed heating________________?
A. decreases with increase in Rankine cycle efficiency
B. increases with increase in Rankine cycle efficiency
C. is unaffected by increase in Rankine cycle efficiency
D. none of the above - In a regenerative feed heating cycle, the greatest economy is affected___________?
A. when steam is extracted from only one suitable point of steam turbine
B. when steam is extracted from several places in different stages of steam turbine
C. when steam is extracted only from the last stage of steam turbine
D. when steam is extracted only from the first stage of steam turbine - The maximum percentage gain in Regenerative feed heating cycle thermal efficiency____________?
A. increases with number of feed heaters increasing
B. decreases with number of feed heaters increasing
C. remains same unaffected by number of feed heaters
D. none of the above - In regenerative cycle feed water is heated by_____________?
A. exhaust gases
B. heaters
C. draining steam from the turbine
D. all above - The cooling section in the surface condenser__________?
A. increases the quantity of vapour extracted along with air
B. reduces the quantity of vapour extracted along with air
C. does not affect vapour quantity extracted but reduces pump capacity of air extraction pump
D. none of the above - In a surface condenser if air is removed, there is___________?
A. fall in absolute pressure maintained in condenser
B. rise in absolute pressure maintained in condenser
C. no change in absolute pressure in the condenser
D. rise in temperature of condensed steam - In a shell and tube surface condenser____________?
A. steam and cooling water mix to give the condensate
B. cooling water passes through the tubes and steam surrounds them
C. steam passes through the cooling tubes and cooling water surrounds them
D. all of the above varying with situation - Binary’vapour cycles are used to_____________?
A. increase the performance of the condenser
B. increase the efficiency of the plant
C. increase efficiency of the turbine - For Parson’s reaction steam turbine, degree of reaction is____________?
A. 75%
B. 100%
C. 50%
D. 60%