A. average load/maximum load.
B. maximum demand/connected load
C. connected load/maximum demand.
D. average load x maximum load
Related Mcqs:
- Load factor of a power station is defined as____________?
A. maximum demand/average load
B. average load x maximum demand
C. average load/maximum demand
D. none of the above - In hydro power plant, the graph between discharge and time is known as___________?
A. monograph.
B. load graph.
C. discharge graph.
D. hydro graph - Diesel power plant are generally used as___________?
A. peak load plant
B. base load plant
C. standby plant
D. none of the above - The critical pressure ratio of a convergent nozzle is defined as_____________?
A. the ratio of outlet pressure to inlet pressure of nozzle
B. the ratio of inlet pressure to outlet pressure of nozzle
C. the ratio of outlet pressure to inlet pressure only when mass flow rate per unit area is minimum
D. the ratio of outlet pressure to inlet pressure only when mass flow rate = c - Reheat factor in steam turbines depends on______________?
A. exit pressure only
B. stage efficiency only
C. initial pressures and temperature only
D. all of the above - The value of reheat factor normally varies from___________?
A. 0.5 to 0.6
B. 0.9 to 0.95
C. 1.02 to 1.06
D. 1.2 to 1.6 - The value of the reheat factor is of the order of_____________?
A. 0.8 to 1.0
B. 1.0 to 1.05
C. 1.1 to 1.5
D. above 1.5 - Which of the following load is responsible for lower power factor of supply system__________?
A. induction motors
B. resistive loads
C. synchronous Motors
D. all of the above - If the diversity factor of a power station is high then its generation cost is___________?
A. high
B. low
C. remain same
D. depend on the plan type - The ideal load factor should be_____________?
A. unity
B. zero
C. negative.
D. infinity.