A. the ratio of outlet pressure to inlet pressure of nozzle
B. the ratio of inlet pressure to outlet pressure of nozzle
C. the ratio of outlet pressure to inlet pressure only when mass flow rate per unit area is minimum
D. the ratio of outlet pressure to inlet pressure only when mass flow rate = c
Related Mcqs:
- The ratio of exit pressure to inlet pressure for maximum mass flow rate per unit area of steam through a nozzle when steam is initially dry saturated is___________?
A. 0.6
B. 0.578
C. 0.555
D. 0.5457 - The ratio of exit pressure to inlet pressure of maximum mass flow rate per area of steam through a nozzle when steam is initially superheated is__________?
A. 0.555
B. 0.578
C. 0.5457
D. 0.6 - The effect of considering friction losses in steam nozzle for the same pressure ratio leads to________?
A. increase in exit velocity from the nozzle
B. decrease in exit velocity from the nozzle
C. no change in exit velocity from the nozzle
D. increase or decrease depending upon the exit quality of steam - The isentropic expansion of steam through nozzle for the steam initially superheated at inlet is approximated by equation__________?
A. pvls=C
B. pv1126 = C
C. pv1A = C
D. pv = C - The isentropic expansion of steam through nozzle for the steam initially dry saturated at inlet is approximated by equation?
A. pv = C
B. pv1A = C
C. pv1i = C
D. pv - The effect of considering friction in steam nozzles for the same pressure ratio leads to_________?
A. increase in dryness fraction of exit steam
B. decrease in dryness fraction of exit steam
C. no change in the quality of exit steam
D. decrease or increase of dryness fraction of exit steam depending upon inlet quality - Rankine cycle operating on low pressure limit of p1 an 1 high pressure limit of p2__________?
A. has higher the renal efficiency than the carnot cycle operating between same pressure limits
B. has lower the”nal efficiency than carnot cycle operating between same pressure limit?
C. has same thermal efficiency as carnot cycle operating between same pressure limits
D. may be more or less depending upon the magnitude of p1 and p2 - Demand factor is defined as___________?
A. average load/maximum load.
B. maximum demand/connected load
C. connected load/maximum demand.
D. average load x maximum load - Load factor of a power station is defined as____________?
A. maximum demand/average load
B. average load x maximum demand
C. average load/maximum demand
D. none of the above - Reheat factor is the ratio of_____________?
A. isentropic heat drop to useful heat drop
B. adiabatic heat drop to isentropic heat drop
C. cumulative actual enthalpy drop for the stages to total is isentropic enthalpy heat drop