A. pvls=C
B. pv1126 = C
C. pv1A = C
D. pv = C
Related Mcqs:
- The isentropic expansion of steam through nozzle for the steam initially dry saturated at inlet is approximated by equation?
A. pv = C
B. pv1A = C
C. pv1i = C
D. pv - The ratio of exit pressure to inlet pressure of maximum mass flow rate per area of steam through a nozzle when steam is initially superheated is__________?
A. 0.555
B. 0.578
C. 0.5457
D. 0.6 - The ratio of exit pressure to inlet pressure for maximum mass flow rate per unit area of steam through a nozzle when steam is initially dry saturated is___________?
A. 0.6
B. 0.578
C. 0.555
D. 0.5457 - The effect of considering friction losses in steam nozzle for the same pressure ratio leads to________?
A. increase in exit velocity from the nozzle
B. decrease in exit velocity from the nozzle
C. no change in exit velocity from the nozzle
D. increase or decrease depending upon the exit quality of steam - Steam turbines commonly used in steam power station are__________?
A. condensing type
B. non-condensing type
C. none of the above - Steam pressure in a steam power station, which is usually kept now-a-days is of the order of____________?
A. 20 kgf/cm2
B. 50 kgf/cm2
C. 100 kgf/cm2
D. 150 kgf/cm2 - The critical pressure ratio of a convergent nozzle is defined as_____________?
A. the ratio of outlet pressure to inlet pressure of nozzle
B. the ratio of inlet pressure to outlet pressure of nozzle
C. the ratio of outlet pressure to inlet pressure only when mass flow rate per unit area is minimum
D. the ratio of outlet pressure to inlet pressure only when mass flow rate = c - The pressure on the two sides of the impulse wheel of a steam turbine_____?
A. is same
B. is different
C. increases from one side to the other side
D. decreases from one side to the other side - Reheat factor in steam turbines depends on______________?
A. exit pressure only
B. stage efficiency only
C. initial pressures and temperature only
D. all of the above - Pipes carrying steam are generally made up of_____________?
A. steel
B. cast iron
C. copper
D. aluminium