A. monograph.
B. load graph.
C. discharge graph.
D. hydro graph
Related Mcqs:
- Diesel power plant are generally used as___________?
A. peak load plant
B. base load plant
C. standby plant
D. none of the above - The overall efficiency of thermal power plant is equal to____________?
A. Rankine cycle efficiency
B. Carnot cycle efficiency
C. Regenerative cycle efficiency
D. Boiler efficiency x turbine efficiency x generator efficiency - Rankine cycle efficiency of a good steam power plant may be in the range of____________?
A. 15 to 20 per cent
B. 35 to 45 per cent
C. 70 to 80 per cent
D. 90 to 95 per ceut - Reheat cycle in steam power plant is used to________________?
A. utilise heat of flue gases
B. increase thermal efficiency
C. improve condenser performance
D. reduce loss of heat - In a steam power plant, the function of a condenser is__________?
A. to maintain pressure below atmospheric to increase work output from the primemover
B. to receive large volumes of steam exhausted from steam prime mover
C. to condense large volumes of steam to water which may be used again in boiler
D. all of the above - Method which is commonly applied for unloading the coal for small power plant is___________?
A. lift trucks
B. coal accelerators
C. tower cranes
D. belt conveyor - In thermal power plant, heat from the flue gases is utilized in___________?
A. super heater
B. condenser
C. economizer
D. chimney - Annual operating expenditure of a power plant consists of_________?
A. fixed charges
B. semi-fixed charges
C. running charges
D. all of the above - Which of the following power plant has highest Depreciation charges?
A. Thermal plant
B. Diesel plant
C. Hydroelectric plant
D. All have same - Which of the following Power Plant causes least environmental pollution____________?
A. Thermal Power Plant
B. Hydro Power Plant
C. Nuclear Power Plant
D. Diesel Power Plant