A. induction motors
B. resistive loads
C. synchronous Motors
D. all of the above
Related Mcqs:
- Load factor of a power station is defined as____________?
A. maximum demand/average load
B. average load x maximum demand
C. average load/maximum demand
D. none of the above - If the load factor of a power station is high then its cost of generation will be_______?
A. High.
B. Low.
C. Remain same.
D. Depend upon plant type. - At low value of power factor, the cost of generation of a power station will be____________?
A. high
B. low
C. remain same
D. none of the above - The ideal load factor should be_____________?
A. unity
B. zero
C. negative.
D. infinity. - Load center in a power station is___________?
A. center of coal fields
B. center of maximum load of equipments
C. center of gravity of electrical system - If the diversity factor of a power station is high then its generation cost is___________?
A. high
B. low
C. remain same
D. depend on the plan type - Load carrying capacity of belt conveyor is about___________?
A. 20 to 40 tonnes/hr
B. 50 to 100 tonnes/hr
C. 100 to 150 tonnes/hr
D. 150 to 200 tonnes/hr - Load curve is useful in deciding the__________?
(a) A. operating schedule of generating units
B. sizes of generating units
C. total installed capacity of the plant
D. all of the above - Reheat factor in steam turbines depends on______________?
A. exit pressure only
B. stage efficiency only
C. initial pressures and temperature only
D. all of the above - Reheat factor is the ratio of_____________?
A. isentropic heat drop to useful heat drop
B. adiabatic heat drop to isentropic heat drop
C. cumulative actual enthalpy drop for the stages to total is isentropic enthalpy heat drop