For a standard 45° fillet, the ratio of size of fillet to throat thickness is_______________?

Related Mcqs:

1. The effective length of a fillet weld should not be less than___________________?

   A. two times the weld size
   B. four times the weld size
   C. six times the weld size
   D. weld size

2. The actual thickness of butt weld as compared to the thickness of plate is usually________________?

   A. more
   B. less
   C. equal
   D. none of the above

3. If the thickness of thinnest outside plate is 10 mm, then the maximum pitch of rivets in tension will be taken as______________?

   A. 120 mm
   B. 160 mm
   C. 200 mm
   D. 300 mm

4. If the thickness of plate to be connected by a rivet is 16 mm, then suitable size of rivet as per Unwin’s formula will be__________________?

   A. 16 mm
   B. 20 mm
   C. 24 mm
   D. 27 mm

5. Minimum thickness of web in a plate girder, when the plate is accessible and also exposed to weather, is______________?

   A. 5 mm
   B. 6 mm
   C. 8 mm
   D. 10 mm

6. The minimum thickness of a steel plate, which is directly exposed to weather and is not accessible for cleaning and repainting, should be___________________?

   A. 4.5 mm
   B. 6 mm
   C. 8 mm
   D. 10 mm

7. The minimum thickness of plates in a steel stack should be___________________?

   A. 4 mm
   B. 5 mm
   C. 6 mm
   D. 8 mm

8. According to IS:800, in the Merchant Rankine formula the value of imperfection index (n) is_______________?

   A. 1.0
   B. 1.4
   C. 1.8
   D. 2.0

9. Other conditions being same, the load factor in indeterminate structures is_______________?

   A. equal to load factor in determinate structures
   B. more than the load factor in determinate structures
   C. less than the load factor in determinate structures
   D. unpredictable

10. The slenderness ratio of a column supported throughout its length by a masonry wall is________________?

    A. zero
    B. 10
    C. 100
    D. infinity