The effective length of a fillet weld should not be less than___________________?

Related Mcqs:

1. For a standard 45° fillet, the ratio of size of fillet to throat thickness is_______________?

   A. 1:1 B. 1 : V2 C. V2 : 1 D. 2: 1...

2. A butt weld is specified by__________________?

   A. effective throat thickness B. plate thickness C. size of weld D. penetration thickness...

3. The actual thickness of butt weld as compared to the thickness of plate is usually________________?

   A. more B. less C. equal D. none of the above...

4. The effective length of a battened strut effectively held in position at both ends but not restrained in direction is taken as________________?

   A. 1.8 L B. L C. 1.1 L D. 1.5 L...

5. According to IS Specifications, the effective length of a column effectively held in position at both ends and restrained in direction at one end is taken as________________?

   A. 0.67 L B. 0.8 L C. L D. 1.5 L...

6. The effective length of a battened column is increased by_________________?

   A. 5% B. 10% C. 15% D. 20%...

7. Normally, the angle of roof truss with asbestos sheets should not be less than_______________?

   A. 26’/2° B. 30° C. 35° D. 40°...

8. The moment of inertia of the pair of vertical stiffeners about the center line of the web should not be less than__________________?

   A. 1.5dV/C B. 1.5d¥/C C. 1.5d¥/C2 D. 1.5dY/C3 where, ‘t’ is the minimum required thick-ness of the web and ‘C is the maximum permitted clear distance between vertical stiffener for thickness ‘t’...

9. The slenderness ratio of a column supported throughout its length by a masonry wall is________________?

   A. zero B. 10 C. 100 D. infinity...

10. If the loaded length of span in meters of a railway steel bridge carrying a single track is 6 m, then impact factor is taken as_________________?

    A. 0 B. 0.5 C. between 0.5 and 1.0 D. 1.0...