The actual thickness of butt weld as compared to the thickness of plate is usually________________?

Related Mcqs:

1. A butt weld is specified by__________________?

   A. effective throat thickness B. plate thickness C. size of weld D. penetration thickness...

2. Minimum thickness of web in a plate girder, when the plate is accessible and also exposed to weather, is______________?

   A. 5 mm B. 6 mm C. 8 mm D. 10 mm...

3. The effective length of a fillet weld should not be less than___________________?

   A. two times the weld size B. four times the weld size C. six times the weld size D. weld size...

4. If the thickness of thinnest outside plate is 10 mm, then the maximum pitch of rivets in tension will be taken as______________?

   A. 120 mm B. 160 mm C. 200 mm D. 300 mm...

5. If the thickness of plate to be connected by a rivet is 16 mm, then suitable size of rivet as per Unwin’s formula will be__________________?

   A. 16 mm B. 20 mm C. 24 mm D. 27 mm...

6. The minimum thickness of a steel plate, which is directly exposed to weather and is not accessible for cleaning and repainting, should be___________________?

   A. 4.5 mm B. 6 mm C. 8 mm D. 10 mm...

7. Bearing stiffener in a plate girder is used to__________________?

   A. transfer the load from the top flange to the bottom one B. prevent buckling of web C. decrease the effective depth of web D. prevent excessive deflection...

8. Rivets connecting flange angles to cover plates in a plate girder are subjected to_________________?

   A. horizontal shear only B. vertical load only C. both (A. and (B. D. none of the above...

9. The forces acting on the web splice of a plate girder are__________________?

   A. axial forces B. shear and axial forces C. shear and bending forces D. axial and bending forces...

10. Economical depth of a plate girder corresponds to_________________?

    A. minimum weight B. minimum depth C. maximum weight D. minimum thickness of web...