If the thickness of thinnest outside plate is 10 mm, then the maximum pitch of rivets in tension will be taken as______________?

Related Mcqs:

1. Pitch of tacking rivets, when double angles connected back to back and acting as tension members should not be more than_________________?

   A. 500 mm B. 600 mm C. 1000 mm D. 300 mm...

2. According to IS Specifications, the maximum pitch of rivets in compression is_____________________?

   A. lesser of 200 mm and 12 t B. lesser of 200 mm and 161 C. lesser of 300 mm and 32 t D. lesser of 3 00 mm and 24 t where t is thickness of thinnest outside plate or angle...

3. Maximum pitch of rivets, used in steel stacks, is limited to_______________?

   A. 6t B. 101 C. 121 D. 161 where t is thickness of thinner plate being connected...

4. As compared to field rivets, the shop rivets are________________?

   A. stronger B. weaker C. equally strong D. any of the above...

5. Minimum thickness of web in a plate girder, when the plate is accessible and also exposed to weather, is______________?

   A. 5 mm B. 6 mm C. 8 mm D. 10 mm...

6. The actual thickness of butt weld as compared to the thickness of plate is usually________________?

   A. more B. less C. equal D. none of the above...

7. For rivets in tension with counter-sunk heads, the tensile value shall be____________________?

   A. reduced by 25 % B. reduced by 33.3% C. increased by 25 % D. increased by 33.3 %...

8. Rivets connecting flange angles to cover plates in a plate girder are subjected to_________________?

   A. horizontal shear only B. vertical load only C. both (A. and (B. D. none of the above...

9. If the thickness of plate to be connected by a rivet is 16 mm, then suitable size of rivet as per Unwin’s formula will be__________________?

   A. 16 mm B. 20 mm C. 24 mm D. 27 mm...

10. The minimum thickness of a steel plate, which is directly exposed to weather and is not accessible for cleaning and repainting, should be___________________?

    A. 4.5 mm B. 6 mm C. 8 mm D. 10 mm...