Which tool is used to measure gap size in a rough alignment?

Related Mcqs:

1. The spark plug gap is normally maintained at________________?

   A. 0.1 to 0.2 mm
   B. 0.2 to 0.4 mm
   C. 0.45 to 0.6 mm
   D. 0.6 to 0.8 mm
   E. 0.8 to 1 mm

2. Which of the following instruments is used to measure flow on the application of Bernoulli’s theorem_________________?

   A. Venturimeter
   B. Orifice plate
   C. nozzle
   D. pitot tube
   E. all of the above

3. The equivalent evaporation of a boiler is a measure to compare _________________?

   A. the given boiler with the model
   B. the two different boilers of the same make
   C. two different makes of boilers operat¬ing under the same operating conditions
   D. two boilers of same make but operaing under different conditions
   E. any type of boilers operating under any conditions

4. Isothermal compression efficiency, even when running at high speed, can be approached by using A. multi-stage compression B. cold water spray C. both A. and B. above D. fully insulating the cylinder E. high stroke_________________?

   Isothermal compression efficiency, even when running at high speed, can be approached by using
   A. multi-stage compression
   B. cold water spray
   C. both A. and B. above
   D. fully insulating the cylinder
   E. high stroke

5. According to Rowan plan, if H = hourly rate, A = actual time and S = standard time, then wages will be___________________?

   A. HA
   B. HA + (S~A) HA
   C. HA + ^^-H
   D. HA + ^^-H
   E. HA + ^^-HA

6. Diesel engines have low specific fuel consumption compared to petrol engine. This statement is____________________?

   A. not true
   B. true at full load
   C. true at part load
   D. true at both part and full load
   E. there could not be any such criterion

7. Air injection in I.C. engines refers to injection of___________________?

   A. air only
   B. liquid fuel only
   C. liquid fuel and air
   D. supercharging
   E. does not exist

8. An engine has a normal speed of 960 r.p.m. and no load speed of 1000 r.p.m. The speed droop of governor will be about___________________?

   A. 2%
   B. 4%
   C. 8%
   D. ±4%
   E. 1%.

9. The basic constituents of Hastelloy are_________________?

   A. aluminium, copper etc
   B. nickel, molybdenum etc
   C. nickel, copper, etc
   D. all of the above
   E. none of the above

10. Basic constituents of Monel metal are _________________?

    A. nickel, copper
    B. nickel, molybdenum
    C. zinc, tin, lead
    D. nickel, lead and tin
    E. none of the above