Isothermal compression efficiency, even when running at high speed, can be approached by using
A. multi-stage compression
B. cold water spray
C. both A. and B. above
D. fully insulating the cylinder
E. high stroke
Related Mcqs:
- For a two stage compressor* if index of compression for higher stage is greater than index of compression for lower stage, then the optimum pressure as compared to ideal case will___________________?
A. increase
B. decrease
C. remain unaffected
D. other factors control it
E. unpredictable - Isothermal compression effeicency can be attained by running the compressor__________________?
A. at very high speed
B. at very slow speed
C. at average speed
D. at zero speed
E. isothermally - The advantage of multistage compression over single stage compression is ________________?
A. lower power consumption per unit of air delivered
B. higher volumetric efficiency
C. decreased discharge temperature
D. moisture free air
E. all of the above - As the number of cylinders in multi-cylinder engine increases, the power to weight ratio_______________?
A. Decreases
B. Increases
C. Remains same
D. Decreases upto a limit and then increases - Isothermal compression though most efficient, but is not -practicable because_________________?
A. ityrequires very big cylinder
B. it does not increase pressure much
C. it is impossible in practice
D. compressor has to run at very slow speed to achieve it
E. it requires cylinder to be placed in water - In multistage compressor, the isothermal compression is achieved by_________________?
A. employing intercooler
B. by constantly cooling the cylinder
C. by running compressor at very slow speed
D. by insulating the cylinder
E. none of the above - For minimum work in multistage compression, assuming same index of compression in all stages_________________?
A. work done in first stage should be more
B. work done in subsequent stages should increase
C. work done in subsequent stages should decrease
D. work done in all stages should be equal
E. work done in any stage is no criterion for minimum work but depends on other factors - An engine has a normal speed of 960 r.p.m. and no load speed of 1000 r.p.m. The speed droop of governor will be about___________________?
A. 2%
B. 4%
C. 8%
D. ±4%
E. 1%. - Compression efficiency is compared against_____________________?
A. ideal compression
B. adiabatic compression
C. botii isothermal and adiabatic compression
D. isentropic compression
E. isothermal compression - The thermal efficiency of a semi-diesel cycle having fixed compression ratio and fixed quantity of heat, with increase in pressure ratio will_______________?
A. increase
B. decrease
C. remain unaffected
D. increase/decrease depending upon engine capacity
E. first increase and then decrease
