A. at very high speed
B. at very slow speed
C. at average speed
D. at zero speed
E. isothermally
Related Mcqs:
- Isothermal compression efficiency, even when running at high speed, can be approached by using A. multi-stage compression B. cold water spray C. both A. and B. above D. fully insulating the cylinder E. high stroke_________________?
Isothermal compression efficiency, even when running at high speed, can be approached by using
A. multi-stage compression
B. cold water spray
C. both A. and B. above
D. fully insulating the cylinder
E. high stroke - Isothermal compression though most efficient, but is not -practicable because_________________?
A. ityrequires very big cylinder
B. it does not increase pressure much
C. it is impossible in practice
D. compressor has to run at very slow speed to achieve it
E. it requires cylinder to be placed in water - Axial flow compressor has the following advantage over centrifugal compressor__________________?
A. larger air handling ability per unit frontal area
B. higher pressure ratio per stage
C. aerofoil blades are used
D. higher average velocities
E. none of the above - The effective power of gas turbines is increased by adding the following in compressor__________________?
A. ammonia and water vapour
B. carbon dioxide
C. nitrogen
D. hydrogen
E. none of the above - In multistage compressor, the isothermal compression is achieved by_________________?
A. employing intercooler
B. by constantly cooling the cylinder
C. by running compressor at very slow speed
D. by insulating the cylinder
E. none of the above - The advantage of multistage compression over single stage compression is ________________?
A. lower power consumption per unit of air delivered
B. higher volumetric efficiency
C. decreased discharge temperature
D. moisture free air
E. all of the above - For minimum work in multistage compression, assuming same index of compression in all stages_________________?
A. work done in first stage should be more
B. work done in subsequent stages should increase
C. work done in subsequent stages should decrease
D. work done in all stages should be equal
E. work done in any stage is no criterion for minimum work but depends on other factors - For a two stage compressor* if index of compression for higher stage is greater than index of compression for lower stage, then the optimum pressure as compared to ideal case will___________________?
A. increase
B. decrease
C. remain unaffected
D. other factors control it
E. unpredictable - The maximum propulsion efficiency of a turbojet is attained at around following speed __________________?
A. 550 km/hr
B. 1050km/hr
C. 1700 km/hr
D. 2400km /hr
E. 4000 km/hr - The overall isothermal eiffciency of compressor is defined as the ratio of_______________?
A. isothermal h.p. to the BHP of motor
B. isothermal h.p. to adiabatic h.p.
C. power to drive compressor to isothermal h.p.
D. work to compress air isothermally to work for actual compression
E. isothermal work to ideal work