A. sinking fund method
B. straight line method
C. A-B-C charging method
D. annuity charging method
E. diminishing balance method
Related Mcqs:
- Heating value of fuel used is as on fired basis. If it is reported for dry or moisture free fuel, then latter should be multiplied by the following factor to correct for as fired value ___________________?
A. (1- moisture content)
B. (1 + moisture content)
C. 1 + moisture content
D. 1 – moisture content - According to MAPI formula, the old machine should be replaced by new one when_____________?
A. CAM < DAM
B. CAM > DAM
C. CAM = DAM
D. there is no such criterion
E. none of the above(CAM = Challenger’s Adverse minimum DAM = Defender’s Adverse minimum)
- The term ‘value’ in value engineering refers to_______________?
A. total cost of the product
B. selling price of the product
C. utility of the product
D. manufactured cost of the product
E. depreciation value - ‘Value’ for value engineering and analysis purposes is defined as_____________________?
A. purchase value
B. saleable value
C. depreciated value
D. present worth
E. function/cost - Auto-ignition reaction time for petrol engine first decreases with increase in fuel air ratio, reaches a minimum value and then increases with subsequent increase in fuel air ratio. The minimum value occurs in the region of________________?
A. Lean mixture
B. Chemically correct fuel air ratio
C. Rich mixture
D. Unpredictable - Which of the following gases has the highest calorific value ________________?
A. producer gas
B. coal gas
C. water gas
D. blast furnace gas
E. coke oven gas - Which of the following solid fuel has high caloric value : ___________?
A. Wood
B. Peat
C. Bituminous coal
D. Anthracite coalSubmitted by: Faheem Zaman Dhaunroo
- According to Rowan plan, if H = hourly rate, A = actual time and S = standard time, then wages will be___________________?
A. HA
B. HA + (S~A) HA
C. HA + ^^-H
D. HA + ^^-H
E. HA + ^^-HA - The ultimate tensile strength of low carbon steel by working at a high strain rate will_________________?
A. decrease
B. increase
C. remain constant
D. first increase and then decrease
E. first decrease and then increase - Value engineering aims at finding out the________________?
A. depreciation value of a product
B. resale value of a product
C. major function of the item and accomplishing the same at least cost without change in quality
D. break even point when machine re-quires change
E. selling price of an item