A. Wood
B. Peat
C. Bituminous coal
D. Anthracite coal
Submitted by: Faheem Zaman Dhaunroo
Related Mcqs:
- The specific fuel consumption for a petrol engine first decreases with increase in fuel air ratio and then increases with further increase in fuel air ratio. The minimum value occurs in the range of__________________?
A. lean mixture
B. chemically correct mixture
C. rich mixture
D. unpredictable
E. none of the above - Heating value of fuel used is as on fired basis. If it is reported for dry or moisture free fuel, then latter should be multiplied by the following factor to correct for as fired value ___________________?
A. (1- moisture content)
B. (1 + moisture content)
C. 1 + moisture content
D. 1 – moisture content - Auto-ignition reaction time for petrol engine first decreases with increase in fuel air ratio, reaches a minimum value and then increases with subsequent increase in fuel air ratio. The minimum value occurs in the region of________________?
A. Lean mixture
B. Chemically correct fuel air ratio
C. Rich mixture
D. Unpredictable - Which of the following solid fuel has high carbon content?
A. Coke
B. Coal
C. Peat
D. None of theseSubmitted by: Faheem Zaman Dhaunroo
- Which is correct statement about reaction time for autoignition of fuel and the fuel air ratio__________________?
A. lean mixture has high reaction time
B. rich mixture has high reaction time
C. chemically correct mixture has mini-mum reaction time
D. all of the above
E. non of the above - The m.e.p. of a petrol engine first increases as the fuel air ratio is increased and then decreases on further increase in fuel air ratio. The M.E.P is maximum in the zone of________________?
A. lean mixture
B. chemically correct mixture
C. rich mixture
D. unpredictable
E. none of the above - Which of the following is mostly used used as blast furnace fuel for extracting pig iron from iron ores?
A. Brown coal
B. Anthracite coal
C. Hard coke
D. Woodchar coalSubmitted by: Faheem Zaman Dhaunroo
- As a result of detonation in an I.C. engine, following parameter attains very high value _____________________?
A. peak pressure
B. rate of rise of pressure
C. rate of rise of temperature
D. peak temperature
E. rate of rise of horse-power - Isothermal compression efficiency, even when running at high speed, can be approached by using A. multi-stage compression B. cold water spray C. both A. and B. above D. fully insulating the cylinder E. high stroke_________________?
Isothermal compression efficiency, even when running at high speed, can be approached by using
A. multi-stage compression
B. cold water spray
C. both A. and B. above
D. fully insulating the cylinder
E. high stroke - Solid injection in I.C. engines refers to injection of________________?
A. liquid fuel only
B. liquid fuel and air
C. solid fuel
D. solid fuel and air
E. does not exist