A. forced lubrication system
B. splash lubrication
C. applying grease under pressure
D. wet sump method
E. mixing about 5% lub oil with petrol
Related Mcqs:
- In a naturally aspirated diesel engine, the air is supplied by________________?
A. a supercharger
B. a centrifugal blower
C. a vacuum chamber
D. an injection tube
E. forced chamber - Tensile strength of steel can be safely in-creased by________________?
A. adding carbon up to 2.8%
B. adding carbon up to 6.3%
C. adding carbon up to 0.83%
D. adding small quantities of copper
E. adding copper and carbon - The compression ratio of motor cars is___________________?
A. 5
B. 7
C. 10
D. 13
E. 16 - Which is correct statement about reaction time for autoignition of fuel and the fuel air ratio__________________?
A. lean mixture has high reaction time
B. rich mixture has high reaction time
C. chemically correct mixture has mini-mum reaction time
D. all of the above
E. non of the above - Petrol is distilled at a temperature in range of__________________?
A. 30 – 65°C
B. 65 – 220°C
C. 220-350°C
D. 350-450°C
E. 450-550°C - The firing order in a six stroke I.C. engine is_________________?
A. 1-3-6-5-2-4
B. 1-4-2-5-6-3
C. 1-6-2-5-4-3
D. 1-5-2-6-3-4
E. 1-5-3-4-2-6 - The specific fuel consumption for a petrol engine first decreases with increase in fuel air ratio and then increases with further increase in fuel air ratio. The minimum value occurs in the range of__________________?
A. lean mixture
B. chemically correct mixture
C. rich mixture
D. unpredictable
E. none of the above - In petrol engines, advancing the spark timing will_______________?
A. increase the knocking tendency
B. decrease the knocking tendency
C. not affect the knocking tendncy
D. increase or decrease knocking tendency depending on strenght and time of spark
E. unpredictable - In isochronous governing, speed droop is_______________?
A. 100%
B. 50%
C. 5%
C. 30%
E. 1%. - The basic requirement of a good combustion chamber is___________________?
A. high compression ratio
B. low compression ratio
C. low volumetric efficiency
D. minimum turbulence
E. high power output and high thermal efficiency