A. adding carbon up to 2.8%
B. adding carbon up to 6.3%
C. adding carbon up to 0.83%
D. adding small quantities of copper
E. adding copper and carbon
Related Mcqs:
- The ultimate tensile strength and yield strength of most of the metals, when temperature falls from 0 to l00°C will _________________?
A. increase
B. decrease
C. remain same
D. first increase and then decrease
E. show unpredictable behaviour - The ultimate tensile strength of low carbon steel by working at a high strain rate will_________________?
A. decrease
B. increase
C. remain constant
D. first increase and then decrease
E. first decrease and then increase - The tensile strength of wrought iron is maximum _________________?
A. along the lines of slag distribution
B. perpendicular to lines of slag distribution
C. uniform in all directions
D. unpredictable
E. none of the above - The loss of strength in compression with simultaneous gain in strength in tension due to overloading is known as________________?
A. hysteresis
B. creep
C. visco elasticity
D. Boeschinger effect
E. inelasticity - The property of a fluid which enables it to resist tensile stress is known as___________________?
A. compressibility
B. surface tension
C. cohesion
D. adhesion
E. viscosity - Surveying tapes are made of a material having low coefficient of expansion and enough strength. The alloy used is__________________?
A. silver metal
B. duralumin
C. Hastelloy
D. monel metal
E. invar - The following element can’t impart high strength at elevated temperature__________________?
A. manganese
B. magnesium
C. nickel
D. silicon
E. none of the above - Compressive strength of grey cast iron in tonnes/cm is of the order of___________________?
A. 3- 5
B. 5-7
C. 7-10
D. 10-15
E. 15-22 - Which of the following has highest specific strength of all structural materials__________________?
A. magnesium alloys
B. titanium alloys
C. chromium alloys
D. magnetic steel alloys
E. none of the above - The system of lubrication used for motor cycles and scooters is by________________?
A. forced lubrication system
B. splash lubrication
C. applying grease under pressure
D. wet sump method
E. mixing about 5% lub oil with petrol