C. transformer
B. d.c. generator
C. capacitor
D. magnetic circuit
E. a.c. generator
Related Mcqs:
- The function of a distributor in an automobile is to__________________?
A. distribute charge, equally to all the cylinders
B. regulate power
C. feed lub oil to all moving parts
D. time the spark
E. inject fuel at appropriate time - Most high speed compression engines operate on __________________?
A. Diesel cycle
B. Otto cycle
C. Dual combustion cycle
D. Special type of air cycle
E. Carnot cycle - Pick up the wrong statement about supercharging __________________?
A. supercharging reduces knocking in diesel engines
B. there can be limited supercharging in petrol engines because of detonation
C. supercharging at high altitudes is essential
D. supercharging results in fuel economy
E. supercharging is essential in aircraft engines - In a typical medium speed 4-stroke cycle diesel engine the inlet valve_____________________?
A. opens at 20° before top dead center and closes at 35° after the bottom dead center
B. opens at top dead center and closes at bottom dead center
C. opens at 10° after top dead center and closes 20° before the bottom dead center
D. may open or close anywhere
E. remains open for 200°. - In a typical medium speed 4-stroke cycle diesel engine________________?
A. compression starts at 35° after bottom dead center and ends at top dead center
B. compression starts at bottom dead center and ends at top dead center
C. compression starts at 10° before bottom dead center and, ends just before top dead center
D. may start and end anywhere
E. none of the above - Supercharging is essential in_____________?
A. diesel engines
B. gas turbines
C. petrol engines
D. aircraft engines
E. marine engines - In the opposed piston diesel engine, the combustion chamber is located________________?
A. above the piston (/;) below the piston
C. between the pistons
D. any when
E. there is no such criterion - The firing order in a six stroke I.C. engine is_________________?
A. 1-3-6-5-2-4
B. 1-4-2-5-6-3
C. 1-6-2-5-4-3
D. 1-5-2-6-3-4
E. 1-5-3-4-2-6 - The system of lubrication used for motor cycles and scooters is by________________?
A. forced lubrication system
B. splash lubrication
C. applying grease under pressure
D. wet sump method
E. mixing about 5% lub oil with petrol - Pick up false statement?
A. For petrol and large gas engines, quantity governingds preferred
B. In quantity governing, air fuel ratio is almost constant and quantity of charge is changed depending on load
C. In hit and miss governing, fuel supply is completely cut off during one or more number of cycles
D. In quality governing, quantity of fuel is varied to suit the load and total charge of air is varied
E. For close regulation of speed, combination of both quality and quantity governing is used