A. Critical
B. Triple
C. Freezing
D. Boiling
Related Mcqs:
- For multi-component multiple phases to be in equilibrium at the same pressure and temperature, the _______________ of each component must be same in all phases?
A. Chemical potential
B. Fugacity
C. Both A. and B
D. Neither A. nor B - “The equilibrium value of the mole fraction of the gas dissolved in a liquid is directly proportional to the partial pressure of that gas above the liquid surface”. This statement pertaining to the solubility of gases in liquid is the ______________ law?
A. Raoult’s
B. Henry’s
C. Amagat’s
D. None of these - At ____________ point, all the three phases (i.e. solid, liquid and gas) co-exist ?
A. Eutectic
B. Triple
C. Plait
D. Critical - The point at which all the three (solid, liquid and gas) phases co-exist, is known as the ____________ point?
A. Freezing
B. Triple
C. Boiling
D. Boyle - When liquid and vapour phases of one component system are in equilibrium (at a given temperature and pressure), the molar free energy is__________________?
A. More in vapour phase
B. More in liquid phase
C. Same in both the phases
D. Replaced by chemical potential which is more in vapour phase - A liquid under pressure greater than its vapour pressure for the temperature involved is called a _____________ liquid?
A. Sub-cooled
B. Saturated
C. Non-solidifiable
D. None of these - At equilibrium condition, the chemical potential of a material in different phases in contact with each other is equal. The chemical potential for a real gas (μ) is given by (where, μ = standard chemical potential at unit fugacity (f° = 1 atm.) and the gas behaves ideally.) ?
A. μ° + RT ln f
B. μ°+ R ln f
C. μ° + T ln f
D. μ° + R/T ln f - The temperature at which a real gas obeys the ideal gas laws over a wide range of pressure is called the ____________ temperature?
A. Critical
B. Boyle
C. Inversion
D. Reduced - While dissolving a gas into a liquid at a constant temperature, the ratio of the concentration of the gas in the solution phase and in the gaseous phase is _______________?
A. Infinity
B. Unity
C. Constant
D. Negative - The compressibility factor of a gas is given by (where, V1 = actual volume of the gas V2 = gas volume predicted by ideal gas law)____________________?
A. V1/V2
B. V2/V1
C. V1 – V2
D. V1.V2