A. Continuously increases
B. Continuously decreases
C. Passes through a maximum
D. Passes through a minimum
Related Mcqs:
- A typical example of an exothermic reversible reaction conducted at high pressure in industry is____________________?
A. Dehydration of ethanol
B. Methanol synthesis
C. Reformation of methane
D. Polymerisation of ethylene - Rate constant for a first order reaction does not depend upon reaction time, extent of reaction and the initial concentration of reactants; but it is a function of reaction temperature. In a chemical reaction, the time required to reduce the concentration of reactant from 100 gm moles/litre to 50 gm moles/litre is same as that required to reduce it from 2 gm moles/litre to 1 gm mole/litre in the same volume. Then the order of this reaction is ?
A. 0
B. 1
C. 2
D. 3 - In a chemical reaction, represented by as shown in the bellow figure, it is observed that the (i) Rate of reaction increases by a factor of 4 on doubling the concentration of the reactant. (ii) Rate of reaction increases by a factor of 9 on trebling the concentration of the reactant. Then the rate of the reaction is proportional to(where, CA = concentration of the reactant)_____________________?
A. CA
B. CA2
C. CA3
D. CA4 - For a vapour phase catalytic reaction (A + B → P) which follows the Ridel mechanism and the reaction step is rate controlling, the rate of reaction is given by (reaction rate is irreversible, product also absorbs) ?
A. -rA = (k . PA . PB)/(1 + KAPA + KPPP)
B. -rA = (k . PA
2 – k1PP)/(1 + KAPA + KPPP)
C. -rA = (k . PA . PB)/(1 + KAPB + KBPB . KPPP)
D. -rA = (k . PA . PB)/(1 + KAPA) - The rate controlling step for the heterogeneous irreversible catalytic reaction A(g) + B(g) → C(g) is the surface reaction of absorbed A with absorbed B to give adsorbed C. The rate expression for this reaction can then be written as (where, KA, KB and KC are the equilibrium constants and is the rate constant of the rate controlling step) ?
A. k KA pApB / (1 + KApA + KBpB)
B. k KAKB pApB / (1 + KApA + KBpB)
C. k KAKB pApB / (1 + KApA + KBpB + KCpC)
D. k KAKB pApB / (1 + KApA + KBpB + KCpC)2 - Fractional conversion _________________ for an exothermic reversible chemical reaction, when the temperature is maximum?
A. Increases
B. Remains unchanged
C. Decreases
D. Unpredictable from the data - Which of the following is the optimum operating condition for an exothermic reversible reaction taking place in a plug-flow reactor ?
A. Temperature should be high in the beginning and decreased towards the end of the reaction
B. Very low temperature should be used throughout the reaction
C. Very high temperature should be used throughout the reaction
D. None of these - For the chemical reaction P → Q, it is found that the rate of reaction doubles as the concentration of ‘P’ is doubled. If the reaction rate is proportional to Cp n, then what is the value of ‘n’ for this chemical reaction ?
A. 0
B. 1
C. 2
D. 3 - The rate of a gas phase reaction is given by K . CA . CB. If the volume of the reaction vessel is reduced to l/4th of its initial volume, then the reaction rate compared to the original rate will be _______________ times?
A. 4
B. 16
C. 8
D. 2 - For a gaseous phase reaction, rate of reaction is equal to K. CA . CB. If the volume of the reactor is suddenly reduced to 1/4th of its initial volume, then the rate of reaction compared to the original rate will be ______________ times?
A. 8
B. 16
C. 1/8
D. 1/16
