A. temperature, time, and turbulance
B. total air, true fuel, and turbulance
C. thorough mixing, total air, and temperature
D. total air, time, and temperature
E. none of the above
Related Mcqs:
- The units of kinematic viscosity are____________________?
A. metres2 per sec
B. kg sec/metre
C. newton-sec per metre
D. newton-sec per metre
E. none of the above - Units of surface tension are____________________?
A. energy/unit area
B. distance
C. both of the above
D. it has no units
E. none of the above - For combustion of a fuel, following is essential_____________________?
A. correct fuel air ratio
B. proper ignition temperature
C. 02 to support combustion
D. all the three above
E. none of the above - Incomplete combustion can be best judged by__________________?
A. smoky chimney exit
B. excess air in flue gases
C. measuring carbon mono-oxide in flue gases
D. measuring temperature of flue gases at exit of furnace
E. measuring oxygen in flue gases - Spontaneous combustion is a phenomenon in which____________________?
A. all the fuel burns instantaneously producing high energy release
B. fuel burns with less air
C. coal bursts into flame without any external ignition source but by itself due to gradual increase in temperature as a result of heat released by combination of oxygen with coal
D. explosion in furnace
E. none of the above - In open combustion chamber in diesel engines____________________?
A. the shape and layout of the piston crown, the inlet port, and the valve produce the turbulent effect on fuel mixture
B. fuel is injected into an auxiliary chamber that is separated from the cylinder by an orifice or throat
C. only a part of air charge is contained in an auxiliary chamber in which the fuel starts to burn with insufficient air which due to explosion tendency mixes thoroughly into main cylinder charge
D. fuel is injected at atmospheric pres¬sure
E. there are no valves. - The basic requirement of a good combustion chamber is___________________?
A. high compression ratio
B. low compression ratio
C. low volumetric efficiency
D. minimum turbulence
E. high power output and high thermal efficiency - At critical point, i.e. p=225.65 kg/cm2, the latent enthalpy of vaporisation is______________?
A. maximum
B. minimum
C. zero
D. depends on temperature also
E. none of the above - Locomotive boiler is of the following type__________________?
A. multitubular
B. horizontal
C. internally fired
D. mobile
E. all of the above - The latent heat of steam with increase of pressure__________________?
A. remains same
B. increases
C. decreases
D. behaves unpredictably
E. none of the above