A. those items which consume money
B. those items which are not readily available
C. those x items which are in more demand
D. those items which consume more money
E. proper quality assurance program-mes
Related Mcqs:
- Standing orders which are statutory are applicable to__________________?
A. all industries
B. all process industries and thermal power plants
C. only major industries
D. only key industries
E. all industries employing more than 100 workers - If TL is the largest allowable event occurrence time, total activity slack (s) is equal to__________________?
A. latest start time – earliest start time
B. latest finish time – earliest finish time (EFT)
C. TL-EFT
D. all of the above
E. none of the above - Piston rings are plated with chromium,cadmium or phosphate in order to__________________?
A. reduce cost
B. improve surface finish
C. prevent clogging
D. reduce wear and eliminate scuffing
E. improve heat transfer - The function of a distributor in an automobile is to__________________?
A. distribute charge, equally to all the cylinders
B. regulate power
C. feed lub oil to all moving parts
D. time the spark
E. inject fuel at appropriate time - Points of arrest for iron correspond to__________________?
A. stages at which allotropic forms change
B. stages at which further heating does not increase temperature for some time
C. stages at which properties do not change with increase in temperature
D. there is nothing like points of arrest
E. none of the above - If partial pressure of air and steam be pa and ps respectively in a condenser, then according to Dalton’s law, the pressure in condenser is equal to__________________?
A. Ps-Pa
B. pa-ps
C. Pa+P
D. non of these - The change in internal energy in steam engines equals to__________________?
A. work done during the rankine cycle ;
B. work done during compression.
C. work done during adiabatic expansion
D. change in enthalpy
E. none of the above - Primary air is the air used to__________________?
A. provide air around burners for obtaining optimum combustion
B. transport and dry the coal
C. convert CO (formed in lower zone of furnace) into C02 at higher zone
D. air-delivered by forced draft fan
E. none ot the above - Feed water conditioning in thermal power plants in done to__________________?
A. reduce hardness and for removal of solids
B. increase efficiency-of thermal power plant
C. increase *heat transfer rate
D. increase steam parameters
E. all of the above - The tensile strength of wrought iron is maximum _________________?
A. along the lines of slag distribution
B. perpendicular to lines of slag distribution
C. uniform in all directions
D. unpredictable
E. none of the above