A. stages at which allotropic forms change
B. stages at which further heating does not increase temperature for some time
C. stages at which properties do not change with increase in temperature
D. there is nothing like points of arrest
E. none of the above
Related Mcqs:
- For the allotropic forms of iron, the points of arrest are __________________?
A. the points where no further change oc-curs
B. constant for all metals
C. the points where there is no further flow of metal
D. the points of discontinuity
E. the points where major changes take place - In order that flow takes place between two points in a pipeline, the differential pressure between these points must be more than_______________?
A. frictional force
B. viscosity
C. surface friction
D. all of the above
E. none of the above - The temperature at which ferromagnetic alpha iron transforms to paramagnetic alpha iron is _______________?
A. 770°C
B. 910°C
C. 1050°C
D. below recrystallisation temperature
E. above recrystallization temperature - An important property of malleable cast iron in comparison to grey cast iron is the high___________________?
A. compressive strength
B. ductility
C. carbon content
D. hardness
E. surface finish - Paramagnetic alpha iron changes to gamma iron at_______________?
A. 770°C
B. 910°C
C. 1440°C
D. 1539°C
E. none of the above - Which of the following is mostly used used as blast furnace fuel for extracting pig iron from iron ores?
A. Brown coal
B. Anthracite coal
C. Hard coke
D. Woodchar coalSubmitted by: Faheem Zaman Dhaunroo
- The function of a distributor in an automobile is to__________________?
A. distribute charge, equally to all the cylinders
B. regulate power
C. feed lub oil to all moving parts
D. time the spark
E. inject fuel at appropriate time - If partial pressure of air and steam be pa and ps respectively in a condenser, then according to Dalton’s law, the pressure in condenser is equal to__________________?
A. Ps-Pa
B. pa-ps
C. Pa+P
D. non of these - The change in internal energy in steam engines equals to__________________?
A. work done during the rankine cycle ;
B. work done during compression.
C. work done during adiabatic expansion
D. change in enthalpy
E. none of the above - Feed water conditioning in thermal power plants in done to__________________?
A. reduce hardness and for removal of solids
B. increase efficiency-of thermal power plant
C. increase *heat transfer rate
D. increase steam parameters
E. all of the above