A. 10 m/sec
B. 25 m/sec
C. 2 m/sec
D. 50 m/sec
E. 250 m/sec
Related Mcqs:
- A model of torpedo is tested in a towing tank at a velocity of 25 m/sec. The prototype is expected to attain a velocity of 5 m/sec. What model scale has been used ?
A. 1 : 5
B. 1 : 2.5
C. 1 :25
D. 1:V5″
E. 1 : 53/2 - For similarity, in addition to models being geometrically similar to prototype, the following in both cases should also be equal____________________?
A. ratio of inertial force to force due to viscosity
B. ratio of inertial force to force due to gravitation
C. ratio of inertial force to force due to surface tension
D. all the four ratios of inertial force to force due to viscosity, gravitation, sur-face tension, and elasticity - The velocity of jet of water travelling out of opening in a tank filled with water is proportional to_________________?
A. head of water (h)
B. h2
C. V/T
D. h2
E. h3/1 - Equivalent evaporation of water is the evaporation “for a feed water supply at 100°C__________________?
A. and its corresponding conversion into dry saturated steam at 100°C and 1.033 kg/cm2
B. and its corresponding conversion into dry steam at desired boiler pressure
C. conversion into steam at atmospheric condition
D. conversion into steam at the same pres-sure at which feed water is supplied
E. none of the above - A model of a reservior is drained in 4 mts by opening the sluice gate. The model scale is 1: 225. How long should it take to empty the prototype ?
A. 900 minutes
B. 4 minutes
C. 4 x (225)3/2 minutes
D. 4 (225)1/3 minutes
E. 4 x V225 minutes - The units of dynamic or absolute viscosity are__________________?
A. metres2 per sec
B. kg sec/meter
C. newton-sec per meter
D. newton-sec2 per meter
E. none of the above - Dynamic viscosity of most of the liquids with rise in temperature__________________?
A. increases
B. decreases
A. remains unaffected
D. unpredictable
E. none of the above - Increase in pressure at the outer edge of a drum of radius R due to rotation at corad/sec, full of liquid of density p will be___________________?
A. pco2/?2
B. pco2/?2/2
C. 2pa2R2
D. pa2R/2
E. none of the above - The evaporation of 15.653 kg of water per hour from and at 100°C is called_________________?
A. evaporative capacity
B. factor of evaporation
C. equivalent evaporation
D. one boiler h.p.
E. boiler efficiency - A square surface 3 m x 3 m lies in a vertical line in water pipe its upper edge at water surface. The hydrostatic force on square surface is____________________?
A. 9,000 kg
B. 13,500 kg
C. 18,000 kg
D. 27,000 kg
E. 30,000 kg
