A. RE consideration
B. RC consideration
C. VCC consideration
D. None of the above
Related Mcqs:
- In voltage divider bias, operating point is 3 V, 2 mA. If VCC = 9 V, RC = 2.2 kO, what is the value of RE ?
A. 2000 O
B. 1400 O
C. 800 O
D. 1600 O - The disadvantage of voltage divider bias is that it has _________________?
A. High stability factor
B. Low base current
C. Many resistors
D. None of the above - For good stabilsation in voltage divider bias, the current I1 flowing through R1 and R2 should be equal to or greater than_____________?
A. 10 IB
B. 3 IB
C. 2 IB
D. 4 IB - In voltage divider bias, VCC = 25 V; R1 = 10 kO; R2 = 2.2 V ; RC = 3.6 V and RE =1 kO. What is the emitter voltage?
A. 7 V
B. 3 V
C. V
D. 8 V - A voltage divider consists of two 68 kΩ resistors and a 24 V source. The unknown output voltage is______________?
A. 12 V
B. 24 V
C. 0 V
D. 6 V - A voltage divider consists of two 100 kΩ resistors and a 12 V source. What will the output voltage be if a load resistor of 1 MΩ is connected to the output?
A. 0.57 V
B. 6 V
C. 12 V
D. 5.7 V - A certain voltage divider consists of two 12 kΩ resistors in series. Which of the following load resistors will have the most effect on the output voltage?
A. 1 MΩ
B. 24 kΩ
C. 18 kΩ
D. 12 kΩ - A certain voltage divider consists of three 1 kΩ resistors in series. Which of the following load resistors will have the least effect on the output voltage?
A. 1 MΩ
B. 100 kΩ
C. 1 kΩ
D. 330 Ω - The current flowing through an unloaded voltage divider is called the____________?
A. bleeder current
B. load current
C. resistor current
D. voltage current - A gain of 1000 times in voltage is expressed by_______________?
A. 60 db
B. 30 db
C. 120 db
D. 600 db
Advertisement