A voltage divider consists of two 68 kΩ resistors and a 24 V source. The unknown output voltage is______________?

Related Mcqs:

1. A voltage divider consists of two 100 kΩ resistors and a 12 V source. What will the output voltage be if a load resistor of 1 MΩ is connected to the output?

   A. 0.57 V
   B. 6 V
   C. 12 V
   D. 5.7 V

2. A certain voltage divider consists of two 12 kΩ resistors in series. Which of the following load resistors will have the most effect on the output voltage?

   A. 1 MΩ
   B. 24 kΩ
   C. 18 kΩ
   D. 12 kΩ

3. A certain voltage divider consists of three 1 kΩ resistors in series. Which of the following load resistors will have the least effect on the output voltage?

   A. 1 MΩ
   B. 100 kΩ
   C. 1 kΩ
   D. 330 Ω

4. Three 10 kΩ resistors are connected in series. A 20 kΩ resistor is connected in parallel across one of the 10 kΩ resistors. The voltage source is 24 V. The total current in the circuit is___________?

   A. 900 μA
   B. 9 mA
   C. 90 mA
   D. 800 μA

5. Two 3.3 kΩ resistors are in series and this series combination is in parallel with a 4.7 kΩ resistor. The voltage across one of the 3.3 kΩ resistors is 12 V. The voltage across the 4.7 kΩ resistor is_________?

   A. 24 V
   B. 12 V
   C. 0 V
   D. 6 V

6. A series resonant band-stop filter consists of a 68 Ω resistor, a 110 mH coil, and a 0.02 µF capacitor. The internal resistance, RW, of the coil is 4 Ω. Input voltage is 200 mV. Output voltage is taken across the coil and capacitor in series. What is the output voltage magnitude at f0?

   A. 1.1 mV
   B. 11.1 mV
   C. 111 mV
   D. 200 mV

7. A series resonant band-pass filter consists of a 2 mH coil, a 0.005 µF capacitor, and a 120 Ω resistor. The winding resistance of the coil is 12 Ω. The output voltage is taken off the resistor. Input voltage is 12 Vrms. What is the output voltage magnitude at the center frequency (f0)?

   A. 10.9 V
   B. 1.09 V
   C. 1.1 V
   D. 12 V

8. A 6 V battery output is divided down to obtain two output voltages. Three 2.2 kΩ resistors are used to provide the two taps. The two output voltages are___________?

   A. 2 V, 4 V
   B. 2 V, 2 V
   C. 2 V, 6 V
   D. 4 V, 6 V

9. In voltage divider bias, VCC = 25 V; R1 = 10 kO; R2 = 2.2 V ; RC = 3.6 V and RE =1 kO. What is the emitter voltage?

   A. 7 V
   B. 3 V
   C. V
   D. 8 V

10. A 12 kΩ resistor, a 15 kΩ resistor, and a 22 kΩ resistor are in series with two 10 kΩ resistors that are in parallel. The source voltage is 75 V. Current through the 15 kΩ resistor is approximately___________?

    A. 14 mA
    B. 1.4 mA
    C. 5 mA
    D. 50 mA