The disadvantage of voltage divider bias is that it has _________________?

Related Mcqs:

1. In voltage divider bias, VCC = 25 V; R1 = 10 kO; R2 = 2.2 V ; RC = 3.6 V and RE =1 kO. What is the emitter voltage?

   A. 7 V B. 3 V C. V D. 8 V...

2. In voltage divider bias, operating point is 3 V, 2 mA. If VCC = 9 V, RC = 2.2 kO, what is the value of RE ?

   A. 2000 O B. 1400 O C. 800 O D. 1600 O...

3. For good stabilsation in voltage divider bias, the current I1 flowing through R1 and R2 should be equal to or greater than_____________?

   A. 10 IB B. 3 IB C. 2 IB D. 4 IB...

4. A voltage divider consists of two 68 kΩ resistors and a 24 V source. The unknown output voltage is______________?

   A. 12 V B. 24 V C. 0 V D. 6 V...

5. A voltage divider consists of two 100 kΩ resistors and a 12 V source. What will the output voltage be if a load resistor of 1 MΩ is connected to the output?

   A. 0.57 V B. 6 V C. 12 V D. 5.7 V...

6. A certain voltage divider consists of two 12 kΩ resistors in series. Which of the following load resistors will have the most effect on the output voltage?

   A. 1 MΩ B. 24 kΩ C. 18 kΩ D. 12 kΩ...

7. A certain voltage divider consists of three 1 kΩ resistors in series. Which of the following load resistors will have the least effect on the output voltage?

   A. 1 MΩ B. 100 kΩ C. 1 kΩ D. 330 Ω...

8. The stability factor of a collector feedback bias circuit is_______________ that of base resistor bias?

   A. The same as B. More than C. Less than D. None of the above...

9. The current flowing through an unloaded voltage divider is called the____________?

   A. bleeder current B. load current C. resistor current D. voltage current...

10. A series resonant band-stop filter consists of a 68 Ω resistor, a 110 mH coil, and a 0.02 µF capacitor. The internal resistance, RW, of the coil is 4 Ω. Input voltage is 200 mV. Output voltage is taken across the coil and capacitor in series. What is the output voltage magnitude at f0?

    A. 1.1 mV B. 11.1 mV C. 111 mV D. 200 mV...