A. decreases with increase in Rankine cycle efficiency
B. increases with increase in Rankine cycle efficiency
C. is unaffected by increase in Rankine cycle efficiency
D. none of the above
Related Mcqs:
- In a regenerative feed heating cycle, the greatest economy is affected___________?
A. when steam is extracted from only one suitable point of steam turbine
B. when steam is extracted from several places in different stages of steam turbine
C. when steam is extracted only from the last stage of steam turbine
D. when steam is extracted only from the first stage of steam turbine - The maximum percentage gain in Regenerative feed heating cycle thermal efficiency____________?
A. increases with number of feed heaters increasing
B. decreases with number of feed heaters increasing
C. remains same unaffected by number of feed heaters
D. none of the above - In regenerative cycle feed water is heated by_____________?
A. exhaust gases
B. heaters
C. draining steam from the turbine
D. all above - Regenerative cycle thermal efficiency_______________?
A. is always greater than simple Rankine thermal efficiency
B. is greater than simple Rankine cycle thermal efficiency only when steam is bled at particular pressure
C. is same as simple Rankine cycle thermal efficiency
D. is always less than simple Rankine cycle thermal efficiency - The isentropic expansion of steam through nozzle for the steam initially superheated at inlet is approximated by equation__________?
A. pvls=C
B. pv1126 = C
C. pv1A = C
D. pv = C - The ratio of exit pressure to inlet pressure for maximum mass flow rate per unit area of steam through a nozzle when steam is initially dry saturated is___________?
A. 0.6
B. 0.578
C. 0.555
D. 0.5457 - The ratio of exit pressure to inlet pressure of maximum mass flow rate per area of steam through a nozzle when steam is initially superheated is__________?
A. 0.555
B. 0.578
C. 0.5457
D. 0.6 - The isentropic expansion of steam through nozzle for the steam initially dry saturated at inlet is approximated by equation?
A. pv = C
B. pv1A = C
C. pv1i = C
D. pv - Steam turbines commonly used in steam power station are__________?
A. condensing type
B. non-condensing type
C. none of the above - Steam pressure in a steam power station, which is usually kept now-a-days is of the order of____________?
A. 20 kgf/cm2
B. 50 kgf/cm2
C. 100 kgf/cm2
D. 150 kgf/cm2