A. when steam is extracted from only one suitable point of steam turbine
B. when steam is extracted from several places in different stages of steam turbine
C. when steam is extracted only from the last stage of steam turbine
D. when steam is extracted only from the first stage of steam turbine
Related Mcqs:
- In a regenerative feed heating cycle, the optimum value of the fraction of steam extracted for feed heating________________?
A. decreases with increase in Rankine cycle efficiency
B. increases with increase in Rankine cycle efficiency
C. is unaffected by increase in Rankine cycle efficiency
D. none of the above - The maximum percentage gain in Regenerative feed heating cycle thermal efficiency____________?
A. increases with number of feed heaters increasing
B. decreases with number of feed heaters increasing
C. remains same unaffected by number of feed heaters
D. none of the above - In regenerative cycle feed water is heated by_____________?
A. exhaust gases
B. heaters
C. draining steam from the turbine
D. all above - Regenerative cycle thermal efficiency_______________?
A. is always greater than simple Rankine thermal efficiency
B. is greater than simple Rankine cycle thermal efficiency only when steam is bled at particular pressure
C. is same as simple Rankine cycle thermal efficiency
D. is always less than simple Rankine cycle thermal efficiency - In a regenerative surface condenser_____________?
A. there is one pump to remove air and condensate
B. there are two pumps to remove air and condensate
C. there are three pumps to remove air, vapour and condensate
D. there is no pump, the condensate gets removed by gravity - Deaerative heating is done to_____________?
Deaerative heating is done to
A. heat the water
B. heat the air in the water
C. remove dissolved gases in the water - Under-feed stokers work best for _________ coals high in volatile matter and with caking tendency?
A. anthracite
B. lignite
C. semibituminous and bituminous - Rankine cycle efficiency of a good steam power plant may be in the range of____________?
A. 15 to 20 per cent
B. 35 to 45 per cent
C. 70 to 80 per cent
D. 90 to 95 per ceut - Rankine cycle operating on low pressure limit of p1 an 1 high pressure limit of p2__________?
A. has higher the renal efficiency than the carnot cycle operating between same pressure limits
B. has lower the”nal efficiency than carnot cycle operating between same pressure limit?
C. has same thermal efficiency as carnot cycle operating between same pressure limits
D. may be more or less depending upon the magnitude of p1 and p2 - Reheat cycle in steam power plant is used to________________?
A. utilise heat of flue gases
B. increase thermal efficiency
C. improve condenser performance
D. reduce loss of heat
