A. shear buckling of web plate
B. compression buckling of web plate
C. yielding
D. all of the above
Related Mcqs:
- Bearing stiffener in a plate girder is used to__________________?
A. transfer the load from the top flange to the bottom one
B. prevent buckling of web
C. decrease the effective depth of web
D. prevent excessive deflection - Minimum thickness of web in a plate girder, when the plate is accessible and also exposed to weather, is______________?
A. 5 mm
B. 6 mm
C. 8 mm
D. 10 mm - Intermediate vertical stiffeners in a plate girder need be provided if the depth of web exceeds___________________?
A. 501
B. 851
C. 200 t
D. 2501where t is thickness of web
- Shear buckling of web in a plate girder is prevented by using________________?
A. vertical intermediate stiffener
B. horizontal stiffener at neutral axis
C. bearing stiffener
D. none of the above - Rivets connecting flange angles to cover plates in a plate girder are subjected to_________________?
A. horizontal shear only
B. vertical load only
C. both (A. and (B.
D. none of the above - The forces acting on the web splice of a plate girder are__________________?
A. axial forces
B. shear and axial forces
C. shear and bending forces
D. axial and bending forces - Economical depth of a plate girder corresponds to_________________?
A. minimum weight
B. minimum depth
C. maximum weight
D. minimum thickness of web - If the thickness of thinnest outside plate is 10 mm, then the maximum pitch of rivets in tension will be taken as______________?
A. 120 mm
B. 160 mm
C. 200 mm
D. 300 mm - In a gusseted base, when the end of the column is machined for complete bearing on the base plate, then the axial load is assumed to be transferred to base plate__________________?
A. fully by direct bearing
B. fully through fastenings
C. 50% by direct bearing and 50% through fastenings
D. 75% by direct bearing and 25% through fastenings - The actual thickness of butt weld as compared to the thickness of plate is usually________________?
A. more
B. less
C. equal
D. none of the above
