A. it has heating value
B. it helps in electrostatic precipitation of ash in flue-gases
C. it leads to corrosion of air heaters, ducting, etc. if flue gas exit temperature is low
D. it erodes furnace walls
E. none of the above
Related Mcqs:
- Heating value of fuel used is as on fired basis. If it is reported for dry or moisture free fuel, then latter should be multiplied by the following factor to correct for as fired value ___________________?
A. (1- moisture content)
B. (1 + moisture content)
C. 1 + moisture content
D. 1 – moisture content - Which is correct statement about reaction time for autoignition of fuel and the fuel air ratio__________________?
A. lean mixture has high reaction time
B. rich mixture has high reaction time
C. chemically correct mixture has mini-mum reaction time
D. all of the above
E. non of the above - The specific fuel consumption for a petrol engine first decreases with increase in fuel air ratio and then increases with further increase in fuel air ratio. The minimum value occurs in the range of__________________?
A. lean mixture
B. chemically correct mixture
C. rich mixture
D. unpredictable
E. none of the above - Which is not correct statement about pulverised fuel firing ?
A. high burning rate is possible
B. heat release can be easily controlled
C. fuel burns economically
D. it is the best technique for burning high ash content fuel having low fusion ash
E. separate mills are required to powder the coal - Auto-ignition reaction time for petrol engine first decreases with increase in fuel air ratio, reaches a minimum value and then increases with subsequent increase in fuel air ratio. The minimum value occurs in the region of________________?
A. Lean mixture
B. Chemically correct fuel air ratio
C. Rich mixture
D. Unpredictable - The m.e.p. of a petrol engine first increases as the fuel air ratio is increased and then decreases on further increase in fuel air ratio. The M.E.P is maximum in the zone of________________?
A. lean mixture
B. chemically correct mixture
C. rich mixture
D. unpredictable
E. none of the above - Sulphur in coal results in___________________?
A. causing clinkering and slagging
B. corroding air heaters
C. spontaneous combustion during coal storage
D. facilitating ash precipitation
E. all of the above - Sulphur content of fuels is very important to the plant operators because it____________________?
A. has high heating value
B. retards electric precipitation
C. promotes complete combustion
D. has highly corrosive effect
E. facilitates ash removal - Diesel engines have low specific fuel consumption compared to petrol engine. This statement is____________________?
A. not true
B. true at full load
C. true at part load
D. true at both part and full load
E. there could not be any such criterion - Sulphur in steel________________?
A. acts as deoxidiser
B. reduces the grain size
C. decreases tensile strength and hardness
D. lowers the toughness and transverse ductility
E. increases hardness
