A. hot hardness
B. toughness
C. wear resistance
D. sharp cutting edge
E. cold hardness
Related Mcqs:
- An engine has a normal speed of 960 r.p.m. and no load speed of 1000 r.p.m. The speed droop of governor will be about___________________?
A. 2%
B. 4%
C. 8%
D. ±4%
E. 1%. - Tungsten in steel________________?
A. improves wear resistance, cutting ability and toughness
B. refines grain size and produces less tendency to carburisation, improves corrosion and heat resistant properties
C. improves cutting ability and reduces hardenability
D. gives ductility, toughness, tensile strength and anticorrosion properties
E. raises its melting point - Isothermal compression efficiency, even when running at high speed, can be approached by using A. multi-stage compression B. cold water spray C. both A. and B. above D. fully insulating the cylinder E. high stroke_________________?
Isothermal compression efficiency, even when running at high speed, can be approached by using
A. multi-stage compression
B. cold water spray
C. both A. and B. above
D. fully insulating the cylinder
E. high stroke - The ultimate tensile strength of low carbon steel by working at a high strain rate will_________________?
A. decrease
B. increase
C. remain constant
D. first increase and then decrease
E. first decrease and then increase - High carbon steel carries carbon %age c_________________?
A. 0.1 to 0.3%
B. 0.3 to 0.6%
C. 0.6 to 0.8%
D. 0.8 to 1.5%
E. 1.5 to 2.5%. - Vanadium in high speed steels__________________?
A. promotes decarburisation
B. provides high hot hardness
C. forms very hard carbides and thus in-creases wear resistance
D. promotes retention of austenite
E. increases toughness - Corrosion resistance of steel is increased by addition of________________?
A. chromium and nickel
B. sulphur, phosphorus, lead
C. vanadium, aluminium
D. tungsten, molybdenum, vanadium, chromium
E. zinc - A reversible change in the atomic structure of the steel with a corresponding change in the properties is known as_________________?
A. allotropic change
B. recrystallisation
C. heat treatment
D. precipitation
E. austempering - Tensile strength of steel can be safely in-creased by________________?
A. adding carbon up to 2.8%
B. adding carbon up to 6.3%
C. adding carbon up to 0.83%
D. adding small quantities of copper
E. adding copper and carbon - The hardness of steel primarily depends on _____________________?
A. %age of carbon
B. %age of alloying elements
C. heat treatment employed
D. method of manufacture
E. shape of carbides and their distribution in iron