A. auto ignition
B. preignition
C. retarded ignition
D. accelerated ignition
E. detonation
Related Mcqs:
- With increase in engine speed, the ignition of spark in petrol engine has to be __________________?
A. Unaltered
B. Increased
C. Decreased
D. Advanced - The operation of forcing additional air under pressure in the engine cylinder is known as________________?
A. scavenging
B. turbulence
C. supercharging
D. pre-ignition
E. dissociation and carburretion of fuel - In order to prevent knock in the S.I. engines, the charge away from the spark plug should have___________________?
A. low temperature
B. low density
C. long ignition delay
D. rich mixture
E. all of the above - If one cylinder of a diesel engine receives more fuel than the others, then for that cylinder the________________?
A. exhaust will be smoky
B. piston rings would stick into piston grooves
C. exhaust temperature will be high
D. engine starts overheating
E. scavenging occurs - The spark plug gap is normally maintained at________________?
A. 0.1 to 0.2 mm
B. 0.2 to 0.4 mm
C. 0.45 to 0.6 mm
D. 0.6 to 0.8 mm
E. 0.8 to 1 mm - The temperature of interior surface of cylinder wall in normal operation is not allowed to exceed____________________?
A. 80°C
B. 120°C
C. 180°C
D. 240°C
E. 320°C - Auto-ignition reaction time for petrol engine first decreases with increase in fuel air ratio, reaches a minimum value and then increases with subsequent increase in fuel air ratio. The minimum value occurs in the region of________________?
A. Lean mixture
B. Chemically correct fuel air ratio
C. Rich mixture
D. Unpredictable - Ignition timing of a multicylider petrol engine can be adjusted by_________________?
A. rotating the crank
B. adjusting the spark plug gap
C. adjusting ignition coil position
D. rotating the distributor
E. delaying the spark by increasing capacitor in ignition circuit - In the case of compression ignition engine, the %age of CO in exhaust gases is________________?
A. Zero
B. 5-10%
C. Depends on load
D. Considerable percent - The most popular firing order in case of four cylinder in-line I.C. engine is__________________?
A. 1-2-3-4
B. 1-3-2-4
C. 1-4-2-3
D. 1-2-4-3
E. 1-3-4-