A. it is the best liquid
B. the height of barometer will be less
C. its vapour pressure is so low that it may be neglected
D. both B. and C.
E. it moves easily
Related Mcqs:
- If mercury in a barometer is replaced by water, the height of 3.75 cm of mercury will be following cm of water________________?
A. 51 cm
B. 50 cm
C. 52 cm
D. 52.2 cm
E. 51.7 cm - A piece of metal of specific gravity 7 floats in mercury of specific gravity 13.6. What fraction of its volume is under mercury ?
A. 0.5
B. 0.4
C. 0.515
D. 0.5
E. none of the above - Alcohol is used in manometer, because____________________?
A. its vapour pressure is low
B. it provides suitable meniscus for the inclined tube
C. its density is less
D. it provides longer length for a given pressure difference
E. it provides accurate readings - Barometer is used to measure__________________?
A. pressure in pipes, channels etc.
B. atmospheric pressure
C. very low pressure
D. difference of pressure between two points
E. rain level - Mercury does not wet glass. This is due to property of liquid known as__________________?
A. adhesion
B. cohesion
C. surface tension
D. viscosity
E. compressibility - Viscosity of water in comparison to mercury is_________________?
A. higher
B. lower
C. same
D. higher/lower depending on temperature
E. unpredictable - A one dimensional flow is one which_________________?
A. is uniform flow
B. is steady uniform flow
C. takes place in straight lines
D. involves zero transverse component of flow
E. takes place in one dimension - Choose the wrong statement ?
A. any weight, floating or immersed in a liquid, is acted upon by a buoyant force
B. Buoyant force is equal to the weight of the liquid displaced
C. The point through which buoyant force acts, is called the center of buoyancy
D. Center of buoyancy is located above the center of gravity of the displaced liquid v
E. Relative density of liquids can be determined by means of the depth of flotation of hydrometer - A hydraulic press has a ram of 15 cm diameter and plunger of 1.5 cm. It is required to lift a weight of 1 tonne. The force required on plunger is equal to_________________?
A. 10 kg
B. 100 kg
C. 1000 kg
D. 1 kg
E. 10,000 kg - A ship whose hull length is 100 m is to travel at 10 m/sec. For dynamic similarity, at what velocity should a 1:25 model be towed through water ?
A. 10 m/sec
B. 25 m/sec
C. 2 m/sec
D. 50 m/sec
E. 250 m/sec