A. hot working
B. tempering
C. normalising
D. annealing
E. special heat treatment
Related Mcqs:
- Cold rolled steel sheets contain carbon of the following order___________________?
A. 0.1%
B. 0.2%
C. 0.4%
D. 0.6%
E. 0.8% - The center of pressure of a surface subjected to fluid pressure is the point_______________?
A. on the surface at which resultant pres-sure acts
B. on the surface at which gravitational force acis
C. at which all hydraulic forces meet
D. similar to metacentre
E. where pressure equivalent to hydraulic thrust will act - A cold chisel is made of_______________?
A. mild steel
B. cast iron
C. H.S.S.
D. high carbon
E. german silver - The following types of materials are usually the most ductile__________________?
A. face-centred cubic lattice
B. body-centred cubic lattice
C. hexagonal close-packed lattice
D. all of the above
E. none of the above - Isothermal compression efficiency, even when running at high speed, can be approached by using A. multi-stage compression B. cold water spray C. both A. and B. above D. fully insulating the cylinder E. high stroke_________________?
Isothermal compression efficiency, even when running at high speed, can be approached by using
A. multi-stage compression
B. cold water spray
C. both A. and B. above
D. fully insulating the cylinder
E. high stroke - Isotropic materials are those which have the same ____________________?
A. elastic properties in all directions
B. stresses induced in all directions
C. thermal properties in all directions
D. electric and magnetic properties in all directions
E. density throughout - The ultimate tensile strength of low carbon steel by working at a high strain rate will_________________?
A. decrease
B. increase
C. remain constant
D. first increase and then decrease
E. first decrease and then increase - Working principle of dead weight pressure gauge tester is based on_______________?
A. Pascal’s law
B. Dalton’s law of partial pressure
C. Newton’s law of viscosity .
D. Avogadro’s hypothesis
E. Second law of thermodynamic - Fire tube boilers are limited to a maximum design working pressure of ____________________?
A. 1 kg/cm
B. 6 kg/cm
C. 17 kg/cm2
D. 100 kg/cm2
E. 250 kg/cm2 - Cyaniding is the process of________________?
A. dipping steel in cyanide bath
B. reacting steel surface with cyanide salts
C. adding carbon and nitrogen by heat treatment of steel to increase its surface hardness
D. obtaining cyanide salts
E. making corrosion resistant steel