A. ability to undergo large permanent deformations in compression
B. ability to recover its original form
C. ability to undergo large permanent deformations in tension
D. all of the above
E. none of the above
Related Mcqs:
- Ductility of a material can be defined as__________________?
A. ability to undergo large permanent deformations in compression
B. ability to recover its original form
C. ability to undergo large permanent deformations in tension
D. all of the above
E. none of the above - Diesel engines as compared to petrol engines require ______________________?
A. bigger flywheel
B. smaller flywheel
C. same size flywheel
D. no flywheel
E. flywheel whose size may be less or more depending on several other fac-tors - An ideal regenerative cycle is ______________________?
A. equal to carnot cycle
B. less than carnot cycle
C. more than carnot cycle
D. could be anything
E. none of the above - Pick up the wrong statement about water tube boiler in comparison to fire tube boilers ______________________?
A. former generates steam at high pressure
B. former occupies less space for same power
C. rate of steam flow is more in former case
D. former is used for high installed capacity
E. chances of explosion are less in former case - Which is not the correct statement about moisture in coal ______________________?
A. inherent moisture and surface mois¬ture are different things
B. in some coals moisture may be present upto 40%
C. some moisture in coal helps in better burning which is not possible with completely dry coal
D. it increases thermal efficiency
E. moisture in coal is removed before firing by heating it with hot air - The feed check valve is used in order to ______________________?
A. regulate flow of boiler water
B. check level of water in boiler drum
C. recirculate unwanted feed water
D. allow high pressure feed water to flow to drum and not allow reverse flow to take place
E. none of the above - The overall isothermal eiffciency of compressor is defined as the ratio of_______________?
A. isothermal h.p. to the BHP of motor
B. isothermal h.p. to adiabatic h.p.
C. power to drive compressor to isothermal h.p.
D. work to compress air isothermally to work for actual compression
E. isothermal work to ideal work - A streamline is defined as the line________________?
A. parallel to central axis flow
B. parallel to outer surface of pipe
C. of equal yelocity in a flow
D. along which the pressure drop is uniform
E. which occurs in all flows - Boiler H.P. is defined as the ________________ ?
A. steam evaporation rate per kg of fuel fired
B. work done in evaporating 1 kg of steam per hour from and at 100°C into dry saturated steam
C. the evaporation of 15.65 kg of water per hour from and at 100°C into dry saturated steam
D. work done by 1 kg of steam at saturation condition
E. heat consumed in evaporating 1 kg water at 0°C to steam at 100°C and 1.033 kg/cm pressure - Argentite is the principal ore or raw material for _________________?
A. aluminium
B. tin
C. zinc
D. lead
E. silver