A. elastic properties in all directions
B. stresses induced in all directions
C. thermal properties in all directions
D. electric and magnetic properties in all directions
E. density throughout
Related Mcqs:
- The following types of materials are usually the most ductile__________________?
A. face-centred cubic lattice
B. body-centred cubic lattice
C. hexagonal close-packed lattice
D. all of the above
E. none of the above - Materials after cold working are subjected to following process to relieve stresses__________________?
A. hot working
B. tempering
C. normalising
D. annealing
E. special heat treatment - The crystal of alpha iron is ____________________?
A. body centred cubic
B. face centred cubic
C. hexagonal close packed
D. cubic structure
E. orthorhombic crystal - Iron is ____________________?
A. paramagnetic
B. ferromagnetic
C. ferroelectric
D. dielectric
E. none of the above - In the case of petrol engine at maximum output, the percentage of CO in exhaust gases is ____________________?
A. Zero
B. 5-10%
C. Depends on load and quality of fuel
D. Considerable percent - For a body floating in a liquid the normal pressure exerted by the liquid acts at ____________________?
A. bottom surface of the body
B. e.g. of the body
C. metacentre
D. all points on the surface of the body
E. all of the above - A body floats in stable equilibrium ____________________?
A. when its meatcentric height is zero
B. when the metancentre is above e.g.
C. when its e.g. is below it’s center of buoyancy
D. metacentre has nothing to do with position of e.g. for determining stability
E. none of the above - Falling drops of water become spheres due to the property of ____________________?
A. adhesion
B. cohesion
C. surface tension
D. viscosity
E. compressibility - Equivalent evaporation is the amount of water evaporated in a boiler from and at ____________________?
A. 0°C
B. 100°C
C. saturation temperature at given pressure
D. room temperature
E. 20°C - Deaeration of feed water is carried out because it reduces ____________________?
A. cavitation of .boiler feed pumps
B. corrosion caused by oxygen
C. heat transfer coefficient
D. pH value of water
E. weight of water to be handled