A. by forming a bulge (l>) by shearing along oblique plane
B. in direction perpendicular to application of load
C. by crushing into thousands of pieces
D. none of the above
Related Mcqs:
- Isothermal compression efficiency, even when running at high speed, can be approached by using A. multi-stage compression B. cold water spray C. both A. and B. above D. fully insulating the cylinder E. high stroke_________________?
Isothermal compression efficiency, even when running at high speed, can be approached by using
A. multi-stage compression
B. cold water spray
C. both A. and B. above
D. fully insulating the cylinder
E. high stroke - The loss of strength in compression with simultaneous gain in strength in tension due to overloading is known as________________?
A. hysteresis
B. creep
C. visco elasticity
D. Boeschinger effect
E. inelasticity - Adiabatic compression is one in which___________________?
A. temperature during compression remains constant
B. no heat leaves or enters the compressor cylinder during cornpression
C. temperature rise follows a linear relationship
D. work done is maximum
E. entropy decreases - The work done per unit mass of air in compression will’be least when n is equal to______________?
A. 1
B. 1.2 ,
C. 1.3
D. 1.4
E. 1.5 - Compression efficiency is compared against_____________________?
A. ideal compression
B. adiabatic compression
C. botii isothermal and adiabatic compression
D. isentropic compression
E. isothermal compression - The compression ratio of motor cars is___________________?
A. 5
B. 7
C. 10
D. 13
E. 16 - The m.e.p. of a diesel cycle having fixed compression ratio with increase in cut-off will_________________?
A. increase
B. decreae
C. be unaffected
D. depend on other factors
E. unpredictable - In petrol engine using a fixed octane rating fuel and fixed compression ratio, super charging will_________________?
A. increase the knocking tendency
B. decrease the knocking tendency
C. not affect the knocking tendency
D. increase or decrease knocking tendency depending on strength and time of spark
E. unpredictable - In the case of compression ignition engine, the %age of CO in exhaust gases is________________?
A. Zero
B. 5-10%
C. Depends on load
D. Considerable percent - The efficiency of the ideal diesel cycle is ________ than that of Otto cycle, for the same compression ratio
A. Higher
B. Lower
C. Equal
D. None of theseSubmitted by: Faheem Zaman Dhaunroo
4 Comments
answer
Correct answer is
By shearing along oblique plane
By shearing along oblique plane
Thanks Iltaf Soomro for updating