A. same level
B. slightly higher level
C. slightly lower level
D. may be anywhere
E. varies from situation to situation
Related Mcqs:
- The specific fuel consumption for a petrol engine first decreases with increase in fuel air ratio and then increases with further increase in fuel air ratio. The minimum value occurs in the range of__________________?
A. lean mixture
B. chemically correct mixture
C. rich mixture
D. unpredictable
E. none of the above - Superheating of steam is done at_________________?
A. constant volume
B. constant temperature
C. constant pressure
D. constant entropy
E. constant enthaply - Which is correct statement about reaction time for autoignition of fuel and the fuel air ratio__________________?
A. lean mixture has high reaction time
B. rich mixture has high reaction time
C. chemically correct mixture has mini-mum reaction time
D. all of the above
E. non of the above - Auto-ignition reaction time for petrol engine first decreases with increase in fuel air ratio, reaches a minimum value and then increases with subsequent increase in fuel air ratio. The minimum value occurs in the region of________________?
A. Lean mixture
B. Chemically correct fuel air ratio
C. Rich mixture
D. Unpredictable - The m.e.p. of a petrol engine first increases as the fuel air ratio is increased and then decreases on further increase in fuel air ratio. The M.E.P is maximum in the zone of________________?
A. lean mixture
B. chemically correct mixture
C. rich mixture
D. unpredictable
E. none of the above - Heating value of fuel used is as on fired basis. If it is reported for dry or moisture free fuel, then latter should be multiplied by the following factor to correct for as fired value ___________________?
A. (1- moisture content)
B. (1 + moisture content)
C. 1 + moisture content
D. 1 – moisture content - Critical path moves along the activities having total float of_____________________?
A. positive value
B. negative value
C. zero value
D. same value
E. none of the above - The total pressure on the surface of a vertical sluice gate 2 m x 1 m with its top 2 m surface being 0.5 m below the water level will be ________________?
A. 500 kg
B. 1000 kg
C. 1500 kg
D. 2000 kg
E. 4000 kg - In open combustion chamber in diesel engines____________________?
A. the shape and layout of the piston crown, the inlet port, and the valve produce the turbulent effect on fuel mixture
B. fuel is injected into an auxiliary chamber that is separated from the cylinder by an orifice or throat
C. only a part of air charge is contained in an auxiliary chamber in which the fuel starts to burn with insufficient air which due to explosion tendency mixes thoroughly into main cylinder charge
D. fuel is injected at atmospheric pres¬sure
E. there are no valves. - In precombustion chamber in diesel engine________________?
A. The shape and layout of the pistion crown, the inlet port, and the valve produce the turbulent effect of fuel mixture
B. Fuel is injected into an auxiliary chamber that is separated from the cylinder by an orifice or throat
C. Only a part of air charge is contained in an auxiliary chamber in which the fuel starts to burn with insufficient air which due to explosion tendency mixes thoroughly into main cylinder charge
D. There are no valves