A. horizontal
B. nearly horizontal
C. steep
D. first rise and then fall
E. none of the above
Related Mcqs:
- When a piping system is made up primarily of vertical lift and very little pipe friction, the pump characteristics should be _________________?
A. horizontal
B. nearly horizontal
C. steep
D. first rise and then fall
E. none of the above - If a pump is handling water and is discharging a certain flow Q at a constant total dynamic head requiring a definite B.H.P., the same pump when handling a liquid of specific gravity 0.75 and viscosity nearly same as of water would discharge_____________________?
A. same quantity of liquid
B. 0.75 Q
C. Q/0.75
D. 1.5 Q
E. none of the above - A turbine pump is basically a centrifugal pump equipped additionally with_________________?
A. adjustable blades
B. backward curved blades
C. vaned diffusion casing
D. inlet guide blades
E. totally submerged operation facility - Head developed by a centrifugal pump depends on___________________?
A. impeller diameter
B. speed
C. fluid density
D. type of casing
E. A. and B. above - In a single casing, multistage pump running at constant speed, the capacity rating is to be slightly lowered. It can be done by_______________?
A. designing new impeller
B. trimming the impeller size to the required size by machining
C. not possible
D. some other alterations in the impeller
E. none of the above - The efficiency of a centrifugal pump is maximum when its blades are__________________?
A. straight
B. bent forward
C. bent backward
D. bent forward first and then backward
E. bent backward first and then forward - In a centrifugal pump, the liquid enters the pump__________________?
A. at the top
B. at the bottom
C. at the center
D. from sides
E. none of the above - Low specific speed of a pump implies it is____________________?
A. centrifugal pump
B. mixed flow pump
C. axial flow pump
D. any one of the above
E. none of the above - For small discharge at high pressure, following pump is preferred_____________________?
A. centrifugal
B. axial flow
C. mixed flow
D. propeller
E. reciprocating - Saving of work done and power by fitting an air vessel to single acting reciprocating pump is of the order of__________________?
A. 39.2%
B. 49.2%
C. 68.8%
D. 84.8%
E. 91.6%.