A. Impulse turbines
B. Reaction turbines
C. Axial flow turbines
D. Mixed flow turbines
E. Reaction-cum-impulse turbines
Related Mcqs:
- Guide angle as per the aerofoil theory of Kaplan turbine blade design is defined as the angle between_________________?
A. lift and resultant force
B. drag and resultant force
C. lift and tangential force
D. lift and drag
E. resultant force and tangential force - Francis turbine is best suited for_____________________?
A. medium head application from 24 to 180 m
B. low head installation up to 30 m
C. high head installation above 180 m
D. all types of heads
E. none of the above - Reaction turbines are used for____________________?
A. low head
B. high head
C. high head and low discharge
D. high head and high discharge
E. low head and high discharge - In axial flow fans and turbines, fluid enters and leaves as follows________________?
A. radially, axially
B. axially, radially
C. axially, axially
D. radially, radially
E. combination of axial and radial - Specific speed for reaction turbines ranges from___________________?
A. 0 to 4.5
B. 10 to 100
C. 80 to 200
D. 250 to 300
E. none of the above - The hydraulic turbines are also known as : ___________?
A. steam turbines
B. water turbines
C. combustion turbines
D. Gas turbinesSubmitted by: Faheem Zaman Dhaunroo
- In a single casing, multistage pump running at constant speed, the capacity rating is to be slightly lowered. It can be done by_______________?
A. designing new impeller
B. trimming the impeller size to the required size by machining
C. not possible
D. some other alterations in the impeller
E. none of the above - Low specific speed of a pump implies it is____________________?
A. centrifugal pump
B. mixed flow pump
C. axial flow pump
D. any one of the above
E. none of the above - The angle of taper on draft tube is A. greater than 15° B. greater than 8° C. greater than 5° D. less than 8° E. less than 3°.___________________?
The angle of taper on draft tube is
A. greater than 15°
B. greater than 8°
C. greater than 5°
D. less than 8°
E. less than 3°. - A hydraulic intensifier normally consists of __________________?
A. two cylinders, two rams and a storage device
B. a cylinder and a ram
C. two co-axial rams and two cylinders
D. a cylinder, a piston, storage tank and control valve
E. special type of pump with storage device and a pressure regulator