The angle of taper on draft tube is
A. greater than 15°
B. greater than 8°
C. greater than 5°
D. less than 8°
E. less than 3°.
Related Mcqs:
- In reaction turbine, draft tube is used_____________________?
A. to transport water downstream without eddies
B. to convert the kinetic energy to flow energy by a gradual expansion of the flow cross-section
C. for safety of turbine
D. to increase flow rate
E. none of the above - Guide angle as per the aerofoil theory of Kaplan turbine blade design is defined as the angle between_________________?
A. lift and resultant force
B. drag and resultant force
C. lift and tangential force
D. lift and drag
E. resultant force and tangential force - The optimum value of vane exit angle for a centrifugal pump impeller is_________________?
A. 10-15°
B. 20-25°
C. 30-40°
D. 50-60°
E. 80-90°. - Maximum impulse will be developed in hydraulic ram when ___________________?
A. waste valve closes suddenly
B. supply pipe is long
C. supply pipe is short
D. ram chamber is large
E. supply pipe has critical diameter - Multistage centrifugal pumps are used to obtain___________________?
A. high discharge
B. high head
C. pumping of viscous fluids
D. high head and high discharge
E. high efficiency - Reciprocating pumps are no more to be seen in industrial applications (in comparison to centrifugal pumps) because of____________________?
A. high initial and maintenance cost
B. lower discharge
C. lower speed of operation
D. necessity of air vessel
E. all of the above - Indicator diagram of a reciprocating pump is a graph between________________?
A. flow vs swept volume
B. pressure in cylinder vs swept volume
C. flow vs speed
D. pressure vs speed
E. swept volume vs speed - A hydraulic intensifier normally consists of __________________?
A. two cylinders, two rams and a storage device
B. a cylinder and a ram
C. two co-axial rams and two cylinders
D. a cylinder, a piston, storage tank and control valve
E. special type of pump with storage device and a pressure regulator - According to fan laws, at constant pressure, the speed capacity and power vary_________________?
A. directly as the air or gas density
B. inversely as square root of density
C. inversely as density
D. as square of density
E. as square root of density - Medium specific speea of turbine implies it is___________________?
A. propeller turbine
B. Francis turbine
C. impulse turbine
D. any one of the above
E. none of the above