A. are used where ease in machining is the criterion
B. contain carbon in free form
C. require least cutting force
D. do not exist
E. can be cut freely even under adverse conditions
Related Mcqs:
- Which of the following element results in presence of free graphite in C.I_________________?
A. carbon
B. sulphur
C. silicon
D. manganese
E. phosphorous - Free air is the air at________________?
A. atmospheric conditions at any specific location
B. 20°C and 1 kg/cm2 and relative humidity of 36%
C. 0°C and standard atmospheric conditions
D. 15°C and 1 kg/cm2
E. 25°C, 1 kg/cm2 and relative humidity of 50%. - An open vessel of water is accelerated up an inclined plane. The free water surface will__________________?
A. be horizontal
B. make an angle in direction of inclination of inclined plane
C. make an angle in opposite direction to inclination of inclined plane
D. any one of above is possible
E. none of the above - In a free vortex motion, the radial component of velocity everywhere is________________?
A. maximum
B. minimum
C. zero
D. non-zero and finite
E. unpredictable - Total pressure on a lmxlm gate immersed vertically at a depth of 2 m below the free water surface will be_______________?
A. 1000 kg
B. 4000 kg
C. 2000 kg
D. 8000 kg
E. 16000 kg - Free surface of a liquid behaves like a sheet and tends to contract to smallest possible area due to the_________________?
A. force of adhesion
B. force of cohesion
C. force of friction
D. force of diffusion
E. none of die above - Free surface of a liquid tends to contract to the smallest possible area due to force of_______________?
A. surface tension
B. viscosity
C. friction
D. cohesion
E. adhesion - On Mollier chart, free expansion, or throttling process from high pressure to atmosphere is represented by_______________?
A. horizontal straight line
B. vertical straight line
C. straight inclined line
D. curved line
E. none of the above - Heating value of fuel used is as on fired basis. If it is reported for dry or moisture free fuel, then latter should be multiplied by the following factor to correct for as fired value ___________________?
A. (1- moisture content)
B. (1 + moisture content)
C. 1 + moisture content
D. 1 – moisture content - The following types of materials are usually the most ductile__________________?
A. face-centred cubic lattice
B. body-centred cubic lattice
C. hexagonal close-packed lattice
D. all of the above
E. none of the above