A. varies as square root of the speed
B. Varies linearly to the speed
C. varies as square of the speed
D. varies as cube of the speed
E. is constant irrespective of variation in speed
Related Mcqs:
- In jet engines, for the efficient production of large power, fuel is burnt in an atmosphere of__________________?
A. vacuum
B. atmospheric air
C. compressed air
D. oxygen alone
E. liquid hydrogen - In jet engines, paraffin is usually used as the fuel because of its _________________?
A. high calorific value
B. ease of atomisation
C. low freezing point
D. A. and C. above
E. none of the above - In jet engines the products of combustion after passing through the gas lurbine are discharged into_______________?
A. atmosphere
B. back to the compressor
C. discharge nozzle
D. vacuum
E. none of the above - In air breathing jet engine, the jet is formed by expanding__________________?
A. gases
B. solids
C. liquid
D. plasma
E. highly heated atmospheric air - In turbo fan engine, the jet velocity as compared to turbo-jet engine is_________________?
A. less
B. more
C. same
D. may be less or more depening upon speed
E. none of the above - The compression ratio in a jet engine varies proportional to ____________________?
A. speed
B. speed
C. altitude
D. Vspeed
E. does not Vary - Isothermal compression efficiency, even when running at high speed, can be approached by using A. multi-stage compression B. cold water spray C. both A. and B. above D. fully insulating the cylinder E. high stroke_________________?
Isothermal compression efficiency, even when running at high speed, can be approached by using
A. multi-stage compression
B. cold water spray
C. both A. and B. above
D. fully insulating the cylinder
E. high stroke - The advantage of multistage compression over single stage compression is ________________?
A. lower power consumption per unit of air delivered
B. higher volumetric efficiency
C. decreased discharge temperature
D. moisture free air
E. all of the above - For minimum work in multistage compression, assuming same index of compression in all stages_________________?
A. work done in first stage should be more
B. work done in subsequent stages should increase
C. work done in subsequent stages should decrease
D. work done in all stages should be equal
E. work done in any stage is no criterion for minimum work but depends on other factors - For a two stage compressor* if index of compression for higher stage is greater than index of compression for lower stage, then the optimum pressure as compared to ideal case will___________________?
A. increase
B. decrease
C. remain unaffected
D. other factors control it
E. unpredictable