The output signal voltage and current of a power amplifier are 5V and 200 mA; the values being r.m.s. What is the power output ?

Related Mcqs:

1. A series resonant band-stop filter consists of a 68 Ω resistor, a 110 mH coil, and a 0.02 µF capacitor. The internal resistance, RW, of the coil is 4 Ω. Input voltage is 200 mV. Output voltage is taken across the coil and capacitor in series. What is the output voltage magnitude at f0?

   A. 1.1 mV
   B. 11.1 mV
   C. 111 mV
   D. 200 mV

2. What will be the collector efficiency of a power amplifier having zero signal power dissipation of 5 watts and a.c. power output of 2 watts ?

   A. 20%
   B. 80%
   C. 40%
   D. 50%

3. An amplifier receives 0.1 W of input signal and delivers 15 W of signal power. What is the power gain in db?

   A. 8 db
   B. 6 db
   C. 5 db
   D. 4 db

4. A series resonant band-pass filter consists of a 2 mH coil, a 0.005 µF capacitor, and a 120 Ω resistor. The winding resistance of the coil is 12 Ω. The output voltage is taken off the resistor. Input voltage is 12 Vrms. What is the output voltage magnitude at the center frequency (f0)?

   A. 10.9 V
   B. 1.09 V
   C. 1.1 V
   D. 12 V

5. In a CE amplifier, the phase difference between voltage across collector load RC and signal voltage is _________________?

   A. 180o
   B. 270o
   C. 90o
   D. 0o

6. The maximum a.c. power output from a class A power amplifier is 10 W. What should be the minimum power rating of the transistor used ?

   A. 10 W
   B. 15 W
   C. 5 W
   D. 20 W

7. The output power of a transistor amplifier is more than the input power because the additional power is supplied by__________________?

   A. Transistor
   B. Biasing circuit
   C. Collector supply VCC
   D. None of the above

8. The power output of an audio system is 18 W. For a person to notice an increase in the output (loudness or sound intensity) of the system, what must the output power be increased to ?

   A. 2 W
   B. 6 W
   C. 68 W
   D. None of the above

9. If the maximum collector current due to signal alone is 3 mA, then zero signal collector current should be at least equal to___________________?

   A. 6 mA
   B. mA
   C. 3 mA
   D. 1 mA

10. A voltage divider consists of two 100 kΩ resistors and a 12 V source. What will the output voltage be if a load resistor of 1 MΩ is connected to the output?

    A. 0.57 V
    B. 6 V
    C. 12 V
    D. 5.7 V